Loading ...
Loading ...
Loading ...
13 ― English
BATTERY PACK AND CHARGER
WARNING!
■ If any part of the charger is missing or
damaged, do not operate it! Replace the
charger with a new one. Failure to heed this
warning could result in possible serious injury.
■ Check the voltage! The voltage must
comply with the information on the rating
label.
BATTERY CHARGING PROCEDURE
■ Align the C-slot of the battery pack with the
T-rail on the Charger. Slide the C-slot onto
the T-rail until the battery pack secures into
place.
■ Connect the charger to the power supply.
■ Allow sufcient charging time (see Product
Specications), and then disconnect the
charger from the power supply.
■ Press the release button on the battery
pack and remove it from the charger.
NOTE:
It is normal for the battery pack and
charger to become warm (but not hot) during
charging process. If the battery does not
charge properly, check to make sure the
electrical outlet is operational. Always charge
the battery before storage!
CHARGING BATTERY PACK
See Figure 4, page ii and 5 - 6, page iii
BATTERY LEDS
BATTERY LED PANEL
■ The panel consists of 2 LEDs on the face
of the battery. Press the panel button for the
LEDs to show you the charge level of the
battery.
■ The battery charge level can be checked
when the battery is attached or removed from
the chainsaw.
Button
Power Indicator LEDs
COLOR BATTERY CAPACITY
Green 50%~100 %
Orange 25%~ 50%
Red 0-25% (Recharge required)
Loading ...
Loading ...
Loading ...