Loading ...
Loading ...
Loading ...
Screw I
Tools Necessary:
and
Flat Head
Screw Driver
Adjustable
Wrench
3/8"
Fixed
Wrench
DOOR REMOVAL INSTRUCTIONS:
A If your refrigerator will not fit through an entrance area, you can reduce its size by
_._ removing the doors. Checkfirst by measuring the entrance.
....._ Top H nge ....
"- Cover IMPORTANT: Before you beg n turn the refrigerator temperature control to 0 and
_' remove the electrical power cord from the wall outlet. Remove food from door shelves.
.....-__ 1. Disconnect electrical supply.
2. Remove toe grille (see figure on page 5).
Top Hinge.._
Toremove freezer door:
1. Remove top hinge cover and screws.
2. Trace around the hinge with a soft lead pencil. This makes reinstallation easier.
3. Remove top hinge and liftdoor off bottom hinge pin.
4. Reinstall door in opposite order and mannerof removal.
/
Toremove refrigerator door:
1. Place wood block under door to support its weight.
2. Unfasten the multi-wire cable bracket by removing its screw from the cabinet.
3. Detach the multi-wire cable connector located below the door.
Place your thumbs on flat sides of each connector, grasp firmly, and bend both
ends back and forth while pulling apart.
NOTE: You may need to insert a flat screwdriver bet_veen the connector ends to
release the locking tab (see illustration).
.Wood Block
4. Detach the water tube from the connector located below the door.The connector
releases when you press itsouter sleeve inward.
b_/, ,,Pin
NOTE: If refrigerator has been used, have a container ready to catch excess water
from tube.
Center
5. Remove the bottom hinge screws and hinge, holding the door as its weight rests
on the wood block. Lay the door on its side to avoid damage to cable and tube.
6. Remove the center hinge screws and hinge. Ensure plastic washer stays on
7. Reinstall door inopposite order and manner of removal. When both doors are
reinstalled, connect water line by inserting tube and pushing until mark touches
face of fitting, Connect cable, replace toe grille, and plug in electrical power cord,
Connector
TO DISCONNECT
1. Pressouter nng against face
Bush untiJ mark touches face of tiffing
Loading ...
Loading ...
Loading ...