PS61201(-S) User Manual

Loading ...

16- ENG

WARNING: Risk of Fire, Asphyxiation and Burn. Never fill fuel tank when

engine is running or hot. Do not smoke when filling fueltank.

• Never fill fuel tank completely. Fill tank to 1/2" (12.7 mm) below bottom of filler

neck to provide space for fuel expansion. Wipe any fuel spillage from engine and

equipment before startingengine.

• DO NOT let hoses come in contact with very hot engine muffler during or

immediately after use of your pressure washer. Damage to hoses from contact with

hot engine surfaces will NOT be covered bywarranty.

NOTICE: Risk of property damage. Never pull water supply hose to move pressure

washer. This could damage hose and/or pumpinlet.

• DO NOT use hot water, use cold wateronly.

• Never turn water supply off while pressure washer engine is running or damage to

pump willresult.

• DO NOT stop spraying water for more than two minutes at a time. Pump operates in

bypass mode when spray gun trigger is not pressed. If pump is left in bypass mode

for more than two minutes internal components of the pump can bedamaged.

If you do not understand these precautions, please contact our customer service

department at www.simpsoncleaning.com

Prior to starting, refer to your engine manual for proper startingprocedure.

1. In a well ventilated outdoor area add fresh, high quality, unleaded gasoline with

a pump octane rating of 86 or higher. Do not overfill. Wipe up spilled fuel before

starting the engine. Refer to Engine Owner's Manual for correctprocedure.

IMPORTANT: Ethanol Shield

(sold separately) is a fuel stabilizer that helps

eliminate and prevent ethanol related problems in power equipment. Follow the

instructions on the container and add to thegasoline.

NOTICE: Use of fuels with greater than 10% ethanol are

not approved for use in this product per EPA regulations

and will damage the unit and void thewarranty.

2. Check engine oil level. Refer to Engine Owner's Manual for correct procedure.

3. Connect the water hose to the water source. Turn the water source on to

remove all air from the hose. When a steady stream of water is present, turn

the water source off.

4. Verify the filter screen (M) is in water inlet of pump. NOTE: Convex side

facesout.

5. Connect water source (N) to pump inlet (J). NOTE: Water source must provide

a minimum of 5 gallons per minute at 20 PSI.

6. Connect

high pressure hose (C) to pump outlet (I).

WARNING: To reduce the possibility of contamination always protect

against backflow when connected to a potable watersystem.

Loading ...

User Manual - Page 16