Loading ...
Loading ...
Loading ...
11
36” FULL GAS RANGE INSTALLATION INSTRUCTIONS
To convert the appliance to propane gas see
"Conversion to Propane gas (LPG)". The conversion
must be done by a qualified technician or installer.
Use a flexible gas pipe with a length of at least 5 ft
(1.5 m). The gas inlet to the unit is located at the
back right of the appliance. Install the pressure
regulator (supplied with the unit) on the gas inlet.
Install the gasket (supplied with the unit) between
the inlet and the regulator. Position the regulator so
that the cap D is easily accessible. Tighten the nut
on the gas inlet so that it is hand tight plus 1/3 turn.
Connect the gas pipe to the regulator using Teflon
tape or pipe-joint compound (resistant to propane
gas and natural gas). Turn so that it is hand tight
plus 1/3 turn. Do not exceed 1 turn for alignment, to
prevent possible damage to the gas pressure
regulator.
1 Gas inlet (attached to the appliance).
2 Gasket.
3 Pressure regulator.
Burners and nozzles technical tables
Cooktop burners:
CAUTION Do not allow regulator to rotate on
pipe when tightening fittings.
WARNING Do not attempt to adjust the pres-
sure regulator, except when converting to propane.
Adjustments could lead to leaks or cause incorrect
gas pressure being supplied to the appliance.
Burner power and bypass table
Burner
No.
12
Max.
Power
(BTU)
18000 12000
Min.
Power
(BTU)
750 750
Bypass
(mm)
75 / 26 55 / 26
Natural gas nozzles table (Pressure in W.C.P.: 5”)
Burner
No.
12
Ext.
nozzle
number
180 135
Int. noz-
zle
number
75 75
LPG nozzles table (Pressure in W.C.P.: 10”)
Burner
No.
12
Ext.
nozzle
number
115 91
Int. noz-
zle
number
48 48
Loading ...
Loading ...
Loading ...