Loading ...
Loading ...
Loading ...
3. 5. Placeclampoverareamarked"CLAMR"Releaseclamp.Cuttheshippingstrapabout16in.(40cm)fromplugend.
Lookforthewords"CUTHERE."Discardendwiththecotter
pins.Slideremainderofshippingstrapfromthepowercord.
Youwillusetheremainderoftheshippingstraplaterto
securethedrainhose.
Properconnectionofthedrainhosewillprotectyourfloorsfrom
damageduetowaterleakage.Topreventthedrainhosefrom
comingofforleaking,itmustbeinstalledperthefollowing
instructions.
IMPORTANT:Toensureproperinstallation,thisproceduremust
befollowedexactly.
1. Checkthedrainhosetoseeifitistheproperlength.
2. Wettheinsideofthestraightendofthedrainhosewithtap
water.DONOTUSEANYOTHERLUBRICANT.
3. Squeezeearsofsilver,double-wireclampwithplierstoopen.
Placeclampoverthestraightendofthedrainhose1/4in.
(6mm)fromtheend.
1/4"
(6 mm)
4. Open clamp. Twist hose back and forth while pushing down
onto drain connector at the bottom of the washer. Continue
until hose contacts the ribbed stop on the cabinet.
/
1.Drain Hose 3. Ribbed Stop
2. Clamp 4. Cabinet
For standpipe or laundry tub drain systems:
1. Open yellow, single-wire clamp with pliers and slide over
hooked end of drain hose to secure the rubber and
corrugated sections together.
!. Hooked end
2. Drain hose
Put hooked end of drain hose into laundry tub or standpipe.
Rotate hook to eliminate kinks.
To prevent drain water from going back into the washer:
• Do not straighten hooked end of drain hose. Do not force
excess drain hose into standpipe. Hose should be secure,
but loose enough to provide a gap of air.
• Do not lay excess drain hose in bottom of laundry tub.
For floor drain installation, see kit number required under
"Alternate Parts."
Loading ...
Loading ...
Loading ...