Loading ...
Loading ...
Loading ...
Installation instructions
ill INSTALLING THE WATER LINE (CONT.)
[] CONNECT THE TUBING
TO THE REFRIGERATOR
NOTES:
• Before making tile c(mnection to tile refrigerator,
be sm'e tile refrigerator power cord is not l_lugged,,
into tile wall outlet.
• We recommend installing a water filter if your water
supply has sand or particles that could clog the
screen of the refl_gerator's water x_dve. Install it ill
the water lille near the refrigerator. If using GE
SmartConnect _'' Refl'igerator Tubing kit, you will
need an additional robe @,_X08X10002) to comlect
tile filter. Do not cut plastic tube to install filter:
ReI//ove tile access coxer. _...._ I
Remove tile plastic flexible
cap from tile water xalve
(refrigerator com_ecti(m),
Place tile compression nut and terrule (sleeve)
onto the end of the tubing as shown. On GE
SmartConnect "_ Refrigerator Tubing kit,
the nuts are ah'eady assembled to tile tubing.
Insert tile end of tile tubing into the water _;dve
connecti(m as fhr as possible. While holding tile
robing, tighten tile fitting.
For plastic tubing fi'om a GE SmartConnect "_
Refi'igerator Tubing kit, insert tile molded end
of tile tubing into the shutoff valve and tighten
compression nut until it is hand tight, then
tighten one additional turn with a wrench.
Overtightening may cause leaks.
Fasten tile tubing into tile clamp provided
to hold it in a vertical position. You may need
to P_T open tile clamp.
1/4"Copper
Tubing
-- TubingClamp
RefrigeratorConnection
1/4"Compression
Nut
(sleeve)
SmartOonnecU
Tubing
Reattach tile access cov:r__,
[] TURN THE WATER
ON AT THE
SHUTOFF VALVE
Tighten any connections
that leak.
[] PLUG IN THE REFRIGERATOR
_rran,*e tile coil of tubing so that it does not vibrate
a _ t
against the back of the refrigerator or against the
wall. Push the refl'igerator back to the wall.
I_]START THE ICEMAKER
On power switch models, set tile icemaker power
switch to the / (0n) position. On fl_eler arm models,
move tile feeler arm to tile ON (down) position. Tile
icemaker will not begin to operate until it reaches
its operating temperature of 15°F (-9°C) or below.
It will then begin operation automatically.
:0w tit
Powerswitch model
+,"_'-- FeelerArminthe
_" STOP(up)position
FeelerArmin
theON(down)position
Feelerarmmodel
NOTE: In lower water pressure conditions, tile
water xalxe max turn on up to 3 times to delixer
enotl(rh water to tile icenlaker.
12
Loading ...
Loading ...
Loading ...