Loading ...
Loading ...
Loading ...
page 9
8. Light Kit Assembly.
Install two 9 watt medium base LED
bulbs (included).
IMPORTANT: When replacing bulbs,
please allow bulbs and shade to cool
down before touching.
Align grooves on shade with nodules
on inside edge of light kit fitter and
push up gently on shade. Twist shade
to the RIGHT (clockwise) until shade
locks into place.
Pull down VERY GENTLY on shade to
make sure that shade is secure.
9. Testing Your Fan.
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with the pull
chain labeled FAN. Start at the OFF position (no blade
movement). First pull will set the fan to HI. Second pull
will set the fan to MEDIUM. Third pull will set the fan to
LOW. Fourth pull will again set the fan to the OFF
setting. Test light with the pull chain labeled LIGHT.
(diagram 1) If fan and/or light do (does) not function,
please refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air depending
on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your comfort.
Important: Reverse switch must be set either
completely LEFT or completely RIGHT for fan to function.
If the reverse switch is set in the middle position
(diagram 4), fan will not operate.
Attach pull chain extensions supplied or custom pull
chain extensions (sold separately) to ends of the pull
chains.
bulb
shade
motor housing
reverse switch
motor housing
diagram 2
diagram 3
diagram 4
diagrama 1
pull chain
extensions
Loading ...
Loading ...
Loading ...