Loading ...
Loading ...
Loading ...
21
TROUBLESHOOTING
Appliance will not operate
• Plug is not fully inserted into the wall outlet
• Blown fuse or circuit breaker
Insuffi cient cooling
• Air fi lter is dirty
• Blocked air fl ow
• Appliance size is too small for application
Noise
• Air movement sound is normal, if it is too loud
set to a lower setting
• Window vibration can be caused by poor
installation, refer to installation instructions or
check with installer
Water dripping inside
• Appliance is not properly angled to allow water
to drain to the outside
Water dripping outside
• On very hot or humid days dripping water from
the back of the appliance is normal
Frost build up
• When outdoor temperatures are below 18.3°C
(65°F) frost may form when the appliance is in
cooling mode
• Switch the appliance to fan only mode until the
frost melts
This Class B digital apparatus complies with CAN
ICES-3 (B) / NMB-3 (B)
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against interference in a residential installation.
This equipment generates, uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation.
If this equipment does cause interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment
and receiver.
3. Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
4. Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifi cations not approved by the
party responsible for FCC compliance could void
the user’s authority to operate the equipment.
This appliance complies with Part 15 of the FCC
Rules.
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference
received, including interference that may cause
undesired operation.
Loading ...
Loading ...
Loading ...