Loading ...
Loading ...
GE Appliances & Lighting
Part Instruction WE49X20697
GE Appliances & Lighting
General Electric Company
Louisville, KY 40225
GEAppliances.com
WH00X5630
2. Remove the belt from the motor
pulley and remove through the
front of the dryer.
To install the drive belt:
1. Reach under the left-hand side of
the drum, push the idler pulley
down and to the right, and lock the
pulley shaft on the top corner of
the motor bracket as shown above.
2. Place the belt in position around
the center of the drum through the
front of the dryer.
3. Place the belt in position around
the motor pulley (see below),
release the idler pulley from the
motor bracket, and guide onto the
belt.
Note: Check to make sure the belt is in
place and not twisted before installing the
top and front panels by rotating the drum
by hand. The ribs of the belt should not be
visible on the drum.
Drum Seal/Felt
The drum seal/felt WE9M30 can be
replaced by removing the seal from the
channel located in the air duct assembly.
Wrap any excess felt around the left hand
side of the air duct assembly.