Loading ...
Loading ...
Loading ...
Open
Mulcher Door
Discharge
deflector
BEFORE STARTING ENGINE
OIL
Your lawn mower is shipped without oil in the
engine.
• Be sure mower is level and area around oil
fillis dean.
• Remove engine oil cap and fillto the full
line on the dipstick.
NOTE: Allow oil to settle down into
engine for accurate dipstick reading.
• Engine holds 20 ozs. of oil. For type and
grade of oilto use, see "ENGINE' in
Maintenance section of this manual.
• Pour oilslowly. Do not over till.
• Check oil level before each use. Add oil if
needed. Fillto fullline on dipstick.
• To read proper level, tighten engine oil cap
each time.
• Reinstall engine oil cap and tighten.
• Change the oil after every 25 hours of
operation or each season. You may need
to change the ell more often under dusty,
dirty cond'fdons.
ADD GASOUNE
NOTE: Beforefillingfuel tank, removeand
discardthe debrisplugthat isinsidethe tank.
• Fillfuel tank. Use fresh, clean, regular
unleaded gasoline with a minimum of 87
octane. Do not mix oil with gasoline.
Purchase fuel in quantitiesthat can be
used within 30 days to assure fuel
freshness.
AWARNING: Experience indicates that
alcohol blended fuels (called gasohol or
using ethanol or methanol) can attract
moisture which leads to separation and
formation of acids during storage. Acidic
gas can damage the fuel system of an
engine while in storage. To avoid engine
problems, the fuel system should be
emptied before storage of 30 days or
longer. Drain the fuel tank, start the
engine and let it run until fuel lines and
carburetor are empty. Use fresh fuel next
season. See Storage Instructions for
additional information. Never use engine
or carburetor cleaner products in fuel tank
or permanent damage may occur.
_]LCAUTION: Fill to bottom of gas tank
filler neck. Do not overfill. Wipe off any
spilled oil or fuel. Do not store, spill or use
gasoline near an open flame.
Gasoline filler _ Engine oil
cap _cap
(Discard _I_'_._X_'j_ l
debris plug _..'_'T" _,_
Inside) "_._
TO START ENGINE
• To start a cold engine, push primer three
(3) times before t_ing to start. Use a firm
push. This step is not usuallynecessary
when startingan engine which has already
runfor a few minutes.
• Hold operator presence control bar down
to the handle and pull starter handle
quickly.Do not allow starterrope to snap
back.
• To stop engine, release operator presence
control bar.
NOTE: In cooler weather itmay be necessary
to repeat primingsteps. In wanner weather
over priming may cause flooding and engine
willnot start. Ifyou do flood engine, wait a few
minutes before attempting to start and do not
repeatp mingsteps.
8
Loading ...
Loading ...
Loading ...