Loading ...
Loading ...
Loading ...
20
Additional Notes on Remote Operations
The remote control has an operating range of 16 ft from the appliance.
The remote signal receiver/sensor is located on the control panel of the air conditioner.
Reception of signal commands is confirmed by an audible beep.
Direct sunlight can interfere with the infrared signal.
To replace batteries, remove the back cover by pressing where indicated and sliding off the
battery cover.
Important:
The air conditioner will not operate if curtains, doors, or other materials block the signals from
the remote control to the unit.
Do not expose the remote control to direct sunlight or heat or allow any liquid to fall onto it as
this could adversely impact its performance.
If the infrared receiver on the unit is exposed to direct sunlight, the unit may not function properly
when operated by the remote control. Use the curtains to prevent sunlight from falling on the
infrared receiver.
If any other electrical appliances react to the remote control, move them away from your air
conditioner.
Important:
This device complies with part 15 of the FCC Rules. Operation subject to the following two
conditions: (1) This device may cause harmful interference to other devices, and (2) This device
must accept any interference received, including interference that may cause undesired
operation.
This device has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Loading ...
Loading ...
Loading ...