Loading ...
Loading ...
Loading ...
Troubleshooting
Trouble Probable Cause Remedy
Power light not illuminated * No Power * Check 120 volt power
source,
• Speed control in off posi- • Turn speed control clock-
tion (See page 7,) wise.
Unit will not run and Fill * Selected humidity level * Raise humidistat setting
Light is not on. has been established,
Note: Red power light
is on.
Unit will not cycle on and
off.
• Humidity control turned al!
the way clockwise to
"Constant On" position.
• Desired humidity not
established,
• Humidifier under size for
requirements.
• Float is not free,
• This is normal,
• Turn humidity control
counter clockwise until the
fan turns oft.
* Allow up to 24 hours of run
time for unit to adjust.
* Designed to satisfy an
area up to 2100 sq, ft.
Unit will not shut off, * Free float from obstruction.
Unit will not dry out * A small amount of water
completely, remains in the base after
the Refill Light comes on.
Bottle continues to empty. • Air is entering the bottle. • Check "E-Z-Fill Side-Cap"
and lower spring assembly
Check for leak in water
bottle.
Ensure gasket for "E-ZoFill
Side-Cap" is in place.
Unit is not emptying during * Dirty filter. Change to a fresh new
use, filter.
Lower spring assembly on Check orientation of bottle,
bottle damaged or missing Reposition so that lower
post in bottom of base, spring valve assembly is
depressed by post in
bottom of base.
CAUTION: Use only 42-14900 EPA Registered Bacteriostat available from Sears
Retail store.
Use of other water treatment products may damage the filter component.
Under no circumstances should you use water treatment products designed for
Roto belt or Ultrasonic humidifiers.
13
Loading ...
Loading ...
Loading ...