Loading ...
Loading ...
Loading ...
15
3.
Check pump oil level.
The oil level should come to the dot in the middle of the sight
glass (U, Fig 2).
4.
In a well-ventilated outdoor area, add fresh, high-quality #2 diesel fuel to the burner
fuel tank fill.
Refer to the Specification Insert for the correct fuel to be used in
the burner.
5.
Visually inspect all electrical components, hoses, nozzles and guns to assure they
are in good condition. If replacements are necessary they must be rated to withstand
the machines operating pressure and temperatures. See
SpecificationInsert.
6.
Connect the water hose to the cold water source. Turn the water source on to
remove all air from the hose. When a steady stream of water is present, turn
the water source off.
NOTE: Use a 5/8" (15.9 mm) or 3/4" (19.0 mm) good
quality water hose of minimal length. NOTE: Water source pressure must be
20–60psi to ensure proper operation.
WARNING: To reduce the possibility of contamination always protect against
backflow when connected to a potable water system.
7.
Verify the filter screen (BB) is in water inlet on the machine.
BB
5
NOTE:
Convex side faces out. Connect the cold water
source to pump inlet (L).
NOTE:
Failure to use machine
without inlet screen filter installed may void warranty.
8. Connect high pressure spray wand (P) to gun (Q). Tighten
securely.
Refer to
Spray Wand Nozzles
to select the
correct quick connect nozzle for the task being performed.
9. Attach high pressure hose (S) to high pressure spray gun
(Q).
Connect the other end of the high-pressure hose to high-pressure hot water
outlet on the machine.
10.
If applying a chemical or cleaning solution, refer to
Chemicals and
CleaningSolvents.
11.
Turn the water source on. Remove all air from the pump and high pressure hose
by depressing trigger until a steady stream of water is present.
NOTICE: Risk of property damage. Failure to do so could cause damage to
thepump.
12.
Make sure ALL controls are in the OFF position.
13.
Start engine. Refer to the
engine instruction manual
for correct procedure.
IMPORTANT: Prior to starting, refer to your engine manual for proper
starting procedure.
WARNING: Risk of unsafe operation. If engine does not start after two pulls,
squeeze trigger of gun to relieve pump pressure. Pull starter cord slowly until resis-
tance is felt. Then pull cord rapidly to avoid kickback and prevent hand or arm injury.
NOTE: If the oil level in the engine is low, the engine will not start. If the engine does
not start, check the oil level and add oil as needed.
14.
If hot water cleaning is desired, release the trigger on the gun and place the burner
On/Off switch (G) in the ONposition.
WARNING: Risk of burns. The surfaces around the burner exhaust and the
discharged exhaust are very hot. Keep away from this area. DO NOT allow hoses
to come in contact with the very hot burner exhaust area.
WARNING: Burner will shut off when the trigger is released. DO NOT use the
pressure washer if the burner fails to shut off when the trigger is released.
15.
Depress trigger on gun to start water flow and the burner.
Loading ...
Loading ...
Loading ...