Kenmore 79033263600 Elite gas cooktop

User Manual - Page 9

For 79033263600.

PDF File Manual, 16 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Setting Surface Controls (cont'd)
Setting the Bridge Burner
The Bridge Burner should be used with rectangular shaped cookware. Cookware
like the cast-iron Griddle that is supplied with your cooktop is designed specifically
for best results with the Bridge Burner.
The Bridge Burner feature may be used to combine the cooking power of 2 or if
needed 3 gas surface Burners located along the left-hand side of the glass
cooktop. The left rear and left center Burners are controlled by the left rear surface
Control Knob. In addition the left front Burner may be added to the Bridge Burner
with the left front gas Control Knob (See Figure 1).
Operating the Bridge Burner
1. Push the left rear surface control knob in and turn counterclockwise out of the
OFF position (See Figure 2).
2. Release the knob and rotate to the LITE position (See Figures 2 & 3). Note: All
electronic surface ignitors will spark at the same time. However, only the
selected surface Burner will lite.
3. Visually check that the left rear Burner has lit.
4. Continue to rotate the gas control knob counterclockwise past the first LO
setting to the arrow marked BRIDGE.
5. Visually check that both the left rear and left center Burners are lit.
6. When both burners are lit, continue to turn the control knob counterclockwise
to adjust to the desired flame size for both burners together. Note: The
markings between the 2nd Hi and LO settings on the left rear control knob are
for adjusting the flame size for both burners (Refer to Figure 3).
7. Add the left front Burner if needed. Once lit, visually adjust the flame size of
the left front Burner to match the flame size of the Bridge Burner.
8. Place cooking utensil centered over the left-hand cooktop surface Burner
Grate. DO NOT cook with any of the surface control knobs in the MTE position
(The electronic ignitor will continue to spark if the knob is left in the MTE
position).
Note: If only the left rear surface Burner is needed, follow the instructions provided
below.
Operating only the Left rear Gas Surface Burner
t. Place cooking utensil centered over the left-rear surface Burner Grate.
2. Push the left rear surface control knob inand turn
counterclockwise out of the OFF position (See
Figure2).
3. Release the knob and rotate to the LITE position.
Note: All electronic surface ignitors will spark at the
same time. However, only the left rear Burner will
ignite.
4. Visually check that the left-rear burner has lit. Adjust
the flame size by turning the control knob between
the first HI and LO settings (See Figure 3). DO
NOT cook with the surface control knob in the LITE
position (The electronic ignitor will continue to spark
if the knob is left in the LITE position).
Left Rear
Burner LITE_f,F
position _/_'_
Figure 1
Figure 2
-Bridge
Burner
flame
adjustment
area
Bridge
m Burner LITE
position
H_J_L_eft Rear Burner
flame adjustment
area
Figure 3
Loading ...
Loading ...
Loading ...