Loading ...
Loading ...
Loading ...
The Kenmore E4 is packaged for conven-
ience and easy handling. It can be easily
assembled using a Phillips head
screwdriver.
Parts include:
• Hex Nut (1)
• Set Screw (1)
• Retainer Screw (1)
• Spacer (1)
1. Slide the Handle Tube into the
Connector Tube. Align the hole in the
Handle Tube with the molded hole at
the top of the Connector Tube. Make
sure the tube is also aligned with the
hole at the base of the Connector Tube
(just above the Dust CaddytM).
2. Place the Hex Nut in the hex-shaped
cavity in the Handle Tube (closest to the
bag). Hold it in place with your finger
while you insert the Set Screw from the
opposite side. While still holding the
Hex Nut in place, tighten the Set Screw
by hand. After a few turns, tighten
further with a Phillips head screw-
driver.
3.
Unzip the Cloth Bag and unsnap the
Collar Retainer by pressing in on the
collar tabs. Slide the Retainer Screw
through the hole at the top of retainer.
Slide the Spacer over the Retainer
Screw and align with the hole in the
Handle Tube. Tighten with a Phillips
head screwdriver. Snap the Collar
Retainer back into place and close the
Cloth Bag.
5. Insert the Connector Plug into the back
of the unit at the rear of the Power Foot.
It should slide under the Safety latch.
Your vacuum cleaner is now ready
to use.
Loading ...
Loading ...
Loading ...