Loading ...
Loading ...
Loading ...
14
found acceptable for use with this model range hood.
• The minimum distance to the hood must be at least 65 cm (about 25”).
Hood installation on ceiling (page 9)
• Remove the Styrofoam protective piece before use.
• The accessories needed for installation are inside the hood.
• Use the two screws to attach the reducer pipe H to the upper platen (Fig. 1). Connect
the 6” non-flammable pipe to the opening in the ceiling.
• Confirm that the ceiling will support the weight of the hood. Drill 4 holes in the ceiling
using a 5/6” bit and insert the plugs (Fig. 2).
• Adjust the length of the telescopic structure and attach the two pieces with 8 screws
and washers. Bear in mind that the minimum distance from working surface to the
base of the hood should not be less than 25” (Fig. 3).
• Attach the previously adjusted telescopic structure to the ceiling using 4 screws and
washers (Fig. 4).
• Introduce pipe J with the grate on the upper part and attach the telescopic structure
using 2 screws (Fig. 4).
• Introduce pipe K and keep it raised (Fig. 5).
• Aix the hood to the telescopic structure using the nuts and washers (Fig. 5).
• Lower pipe K and attach it to the hood with 2 screws (Fig. 5)
Connecting the hood to the grid
Warning: Before connecting the hood: Switch o the electricity supply and
check that the supplied voltage and frequency coincide with that indicated on
the appliance nameplate.
Connect the hood directly to the electrical grid, protected by a separator device
accessible for disconnection, in line with local regulations.
USE OF THE HOOD
WARNING: NOT SUITABLE FOR USE WITH SOLID-STATE SPEED CONTROLS.
Safety
Warning: The hood may stop working during an electrostatic discharge (e. g.
lightning). This involves no risk of damage. Switch o the electrical supply to the
hood and reconnect after one minute.
Do not allow the hood to be used by children or persons with reduced (physical, sensory
Loading ...
Loading ...
Loading ...