Loading ...
Loading ...
Loading ...
5
is advisable to let it run for at least 15 minutes with the
thermostat at the maximum setting and then ventilate
the room. A little smoke may be emitted due to the
protective substances applied to the heating element
before transport.
- Do not position the appliance on deep-pile carpets or
rugs, to avoid obstruction to the air intake grille located
under it.
- Do not obstruct the hot air outlet grille or the air intake
grille on the bottom of the appliance.
- Position the appliance so that the plug and the power
socket can be easily reached after installation.
- Do not use this appliance in a room whose surface area is
less than 4 m
2
.
- An anti-tilt safety device turns the appliance o if it falls
over or is positioned inappropriately so as to jeopardise
safety. The appliance resumes operation after being
placed in an upright position again.
- The appliance is tted with a safety cuto device
which will switch the appliance o in case of accidental
overheating.
To reset the cuto, disconnect the plug from the power
socket for a few minutes, remove the cause of overheating
then reconnect the appliance. If this abnormal situation
happens several times, contact customer service.
This appliance conforms to the following EC directive:
- Directive on electromagnetic compatibility (EMC) and
subsequent amendments
Use in compliance with intended use
Use this heater only as described in this manual. All other
use is considered improper.
This appliance is not suitable for commercial use.
The manufacturer is not liable for damage deriving from
improper use of the appliance. This is a household appliance
only. It is not intended to be used in:
• staff kitchen areas in shops, offices and other working
environments;
• farm houses;
• by clients in hotels, motels and other residential type
environments;
• bed and breakfast type environments.
Use in this manner will invalidate the manufacturers
warranty.
Fundamental recommendations regarding safety
Dear Customer – The plug on this appliance will get ‘warm’
during use, this is perfectly normal.
This product is A HIGH POWER HEATING APPLIANCE designed
to our usual high standards but please make sure your wall
sockets are in good condition and the plug is inserted
correctly to avoid any accidental overheating.
We suggest that you check the plug AND THE SOCKET
regularly if the heater is in prolonged use, if you are in any
doubt please consult an electrician.
DESCRIPTION
A Warning lamp
B Thermostat
C Power selector
D Slider
E Timer
General instructions
Remove the appliance from the packaging.
Check that neither the appliance nor the power cable has
been damaged during transport. Do not operate the heater if
damaged.
Remove all publicity material from the appliance. The
appliance is suitable for free-standing or wall-mounted usage.
Do not assemble the feet if wall-mounted.
Electrical connection
- Before connecting the appliance to the power socket,
check that the voltage indicated on the appliance rating
plate is the same as your electrical system and that it can
support the power consumption (Watt) indicated.
- If more than one appliance is used at the same time, it is
important to ensure that the electrical system is able to
support the power required.
Use on the oor, feet assembly
Tools required:
Screwdriver PH2x100 (crosshead)
2 supplied screws 3.5x13 PH (F)
Place the appliance on a stable surface.
For mounting the feet, proceed as follows:
- Insert the two hooks in the slots and rotate the foot until
it is engaged as shown in gure 2.
- Insert the two pins in their respective holes.
- Fix the foot with the screw (F) supplied (gure 3).
- See Figure 4 for the minimum distances of the device
from the walls. The measurements are indicated both for
models equipped with fan "
"
and for models without.
Loading ...
Loading ...