Loading ...
Loading ...
Loading ...
Thermostat (T) - see Fig. 3
In order to maintain a certain room temperature,
set the controller to ‘max.’. Operate the appliance
at full power until the required room temperature
is reached. Turn back the thermostatic controller
until the appliance switches off with an audible
“click”. This temperature will be kept almost
constant by the thermostatic control switching
on and off automatically.Please note that the
appliance can only be switched on when the
thermostat setting is higher then the room
temperature.
Thermal Safety Cut-out
The built-in overheat cut-out switches off the
appliance automatically in the event of a fault.
Switch off the appliance or disconnect the mains
plug from the socket. After a short cooling down
phase, the appliance is ready for use again. If the
fault should occur again, see your local dealer.
Light Emitting Diode
This appliance is tted with LED (Light Emitting
Diode) lamps. These LED lamps are maintenance-
free and should not require replacing during the life
of the product.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE
POWER SUPPLY BEFORE ATTEMPTING ANY
MAINTENANCE.
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE
POWER SUPPLY BEFORE CLEANING THE
HEATER.
For general cleaning use a soft clean duster – never
use abrasive cleaners. The glass viewing screen
should be cleaned carefully with a soft cloth. DO
NOT use proprietary glass cleaners.
To remove any accumulation of dust or uff the
soft brush attachment of a vacuum cleaner should
occasionally be used to clean the outlet grille of
the fan heater.
Recycling
At the end of the electrical products
useful life it should not be disposed of
with household waste. Please recycle
where facilities exist. Check with
your Local Authority or retailer for recycling advice
in your country.
After Sales Service
Should you require after sales service or should
you need to purchase any spares, please contact
the retailer from whom the appliance was pur-
chased or contact the service number relevant to
your country on the warranty card.
Please do not return a faulty product to us in the
rst instance as this may result in loss or damage
and delay in providing you with a satisfactory
service. Please retain your receipt as proof of
purchase.