Loading ...
Loading ...
Loading ...
TemperatureControls
Touch Temperature Controls
The controls are located at the top front of the
refrigerator compartment.
Control
Initial Control Settings
After plugging the refrigerator in, set the controls.
• Pressing the {I or {_ pads adjusts the controls to
the desired setting.
• The temperature control range for both
compartments is 1 through 7 Ccoldest).
• Initially set the refrigerator control on 4.
• Initially set the freezer control on 4.
• Let the refrigerator run at least 8 to 12 hours before
adding food.
Warm Cabinet Surfaces
At times, the front of the refrigerator cabinet may be
warm to the touch. This is a normal occurrence that
helps prevent moisture from condensing on the
cabinet. This condition Will be more noticeable when
you first start the refrigerator, during hot weather and
after excessive or lengthy door openings.
Adjusting the Controls
24 hours after adding food, you may decide that one
or both compartments should be colder or warmer. If
so, adjust the controlCs_}as indicated in the
Temperature Control Guide table below. See page 19
for instructions on checking compartment
temperature.
• Except when starting the refrigerator, do not change
either control more than one number at a time.
• Allow 24 hours for temperatures to stabilize.
• Changing either control will have some effect on the
temperature of the other compartment.
Temperature Control Guide
Refrigerator too warm Set the refrigerator control
to next higher number by
pressing the {_ pad.
Refrigerator too cold Set the refrigerator control
to next lower number by
pressing the {1 pad.
Freezer too warm Set the freezer control to
next higher number by
pressing the {_ pad.
Freezer too cold Set the freezer control to
next lower number by
pressing the_ pad.
Turn refrigerator OFF Press the refrigerator or
freezer {1 pad until a dash
C-) appears in the display.
Energy Saver Switch [select models)
Off - The refrigerator uses more energy when this
switch is off, because a heater located in the hinged
seal section of the door is running. This heater helps
prevent condensation formation on the exterior of the
hinged seal. Turn the energy saver switch OFF when
the environment is warm and more humid or if
moisture is noticed on the door exterior.
• On - This setting saves energy by not using the
heater. Turn the energy saver switch ON when the
environment is less humid.
Loading ...
Loading ...
Loading ...