Craftsman 917293321 6.5-hp rear-tine tiller

User Manual - Page 11

For 917293321.

PDF File Manual, 39 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Oil Fill
ADD GASOLINE
Fill fuel tank. Use fresh, clean, regular
unleaded gasoline. (Use of leaded
gasoline will increase carbon and lead
oxide deposits and reduce valve life.
IMPORTANT: When operating in tem-
peratures below 32°F (0°C), use fresh,
clean, winter grade gasoline to help
insure good cold weather starting.
_I,WARNING: Experience indicates that
alcohol blended fuels (called gasohol or
using ethanol or methanol) can attract
moisture which leads to separation and
formation of acids during storage. Acidic
gas can damage the fuel system of an
engine while in storage. To avoid engine
problems, the fuel system should be
emptied before storage of 30 days or
longer. Drain the gas tank, start the
engine and let it run until the fuel lines
and carburetor are empty. Use fresh fuel
next season. See Storage section of this
manual for additional information. Never
use engine or carburetor cleaner prod-
ucts in the fuel tank or permanent
damage may occur.
_:_CAUTION: Fill to within 1/2 inch of top
of fuel tank to prevent spills and to allow
for fuel expansion, tf gasoline is acciden-
tally spilled, move machine away from
area of spill. Avoid creating any source of
ignition until gasoline vapors have
disappeared.
Do not overfill. Wipe off any spilled oil or
fuel. Do not store, spill or use gasoline
near an open flame.
TO START ENGINE
_CAUTION: Keep drive control bar in
"DISENGAGED" position when starting
engine.
When starting engine for the first time or if
engine has run out of fuel, it will take
extra pulls of the recoil starter to move
fuel from the tank to the engine.
Make sure spark plug wire is properly
connected.
Move shift lever indicator to "N"
(neutral) position.
Place throttle control in "FAST" position.
Turn fuel shut-off valve 1/4 turn to
OPEN position.
Move choke control to CHOKE position.
Grasp recoil starter handle with one
hand and grasp tiller handle with other
hand. Pull rope out slowly until engine
reaches start of compression cycle
(rope will pull slightly harder at this
point).
Pull recoil starter handle quickly. Do
not let starter handle snap back against
starter.
If engine fires but does not start, move
choke control to half choke position.
Pull recoil starter handle until engine
starts.
When engine starts, slowly move choke
control to "RUN" position as engine
warms up.
NOTE: A warm engine requires less
choking to start.
Move throttle control to desired running
position.
Allow engine to warm up for a few
minutes before engaging tines.
NOTE: If at a high altitude (3000 feet) or
in cold temperatures (below 40°F), the
carburetor fuel mixture may need to be
adjusted for best engine perfomrance.
See "TO ADJUST CARBURETOR" in the
Service and Adjustments section of this
manual.
NOTE: If engine does not start, see
troubleshooting points.
11
Fuel shut-off Choke controls
Rewind starter _._
TILLING HINTS
h_CAUTION: Until you are accustomed to
andling your tiller, start actual field use
with throttle in slow position (mid-way
between "FAST" and "IDLE").
Loading ...
Loading ...
Loading ...