Loading ...
Loading ...
Loading ...
9
2. Installing the Cooktop
There are four mounting brackets supplied with the electric cooktop. These brackets are designed to
hold the cooktop firmly in place. The cooktop should be bedded to the countertop using a soft
bedding compound that will prevent damage if later removal for service is necessary. We
recommend a very small bead of silicone sealant.
Position the cooktop in the cutout opening and press firmly on all sides to seal the frame into the
bedding compound. Secure the mounting brackets to the cooktop from underneath with the screws
that are supplied as shown below.
Electrical Connection
• The appliance must be properly installed and grounded by a qualified technician in accordance
with the National Electrical Code ANSI/NFPA No. 70 (Latest Edition) and local electrical code
requirements. Installation should be made by a licensed electrician.
• The unit may be connected by means of permanent Hard Wiring or Power Supply Cord Kit.
Power supply cord is not supplied, but is available through your local electric supply house.
• Use only 3-conductor or 4-conductor UL listed cord rated at 20 amps with 250V minimum voltage
range. These cords may be provided with strain relief or conduit connector.
• The unit must be connected to the proper electrical voltage and frequency as specified on the
rating label.
• The unit should be connected directly to the junction box through flexible, armored or nonmetallic
sheathed, copper cable. The flexible, armored cable extending from the fuse box or circuit
breaker box should be connected directly to the junction box. Locate the junction box to allow as
much slack as possible between the junction box and the unit so that the unit can be moved if
servicing becomes necessary in the future.
• Do not cut the conduit. Use the length of conduit provided.
• For personal safety, the appliance must be properly grounded.
• Remove house fuse or open circuit breaker before beginning installation.
• Do not attempt to repair or replace any part of the appliance unless it is specifically
recommended in this manual. All other servicing should be referred to a qualified technician.
• To minimize the possibility of electric shock, disconnect this appliance from the A/C power
supply before attempting any maintenance.
• Before install this appliance, please check the rating on the rating label located on the rear cover
of this appliance.
NOTE: Turning the appliance off does not disconnect the appliance from the power supply. We
recommend having a qualified technician service your appliance.
Loading ...
Loading ...
Loading ...