Loading ...
Loading ...
Loading ...
DOOR REMOVAL (UPRIGHT MODELS)
If door must be removed to fit through narrow doorways,
1 Gently lay freezer on its back, on a throw rug or
blankeL
2, Remove the base panel by unscrewing two screws
from front of base panel. Remove wire from clips on
bottom of cabinet (Figure I)
3 Unplug connector by holding the cabinet connector in
piace, and pulling door connector out (Figure 1)
4 At the top of the cabinet, tift up plastic hinge cover, and
fold back (Figure 2)
5 Use a Phillips@ screwdriver to loosen and retighten
the screws on the top hinge to insure a secure
assembly, and prevent hinge slippage,
6 Remove the top hinge from cabinet, and lift door off
lower hinge pin
7 After door is removed, remove the two screws from the
bottom hinge
8 To replace door, reverse above order
Door Connector
Cabinet Connector
Figure 1
SCreWS
Top
Hinge -_
Plastic
Hinge Cover
Upright Freezer' Doo_ Adjustments
Figure 2
. The freezer should be located in the coolest area of the
room, away from heat producing appliances or heating
ducts, and out of direct sunlight
• Let hot foods coot to room temperature before ptacing in
the freezer Overloading the freezer forces the compres-
sor to run longer Foods that freeze too slowly may lose
quality or spoil
o Be sure to wrap foods properly, and wipe containers dry
before placing them in the freezer This cuts down on
frost build-up inside the freezer
• Freezer shelves should not be lined with aluminum foil,
wax paper, or paper toweling, Liners interfere with cold
air' circulation, making the freezer less efficient
o Organize and label food to reduce door openings and
extended searches Remove as many items as needed
at one time, and close the door as soon as possible
COOL DOWN PERIOD
For safe food storage, allow 4 hours for the freezer' to
cool down completely The freezer wilt run continuously
for the first several hours Foods that are already frozen
may be placed in the freezer' after the first few hours of
operation Unfrozen foods should NOT be loaded into
the freezer until the freezer has operated for 4 hours
When toading the freezer, freeze only 3 pounds of
fresh food per cubic foot of freezer space at one time
Distribute packages to be frozen evenly throughout the
freezer It is not necessary to turn the control knob to a
colder setting while freezing food
TEMPERATURE CONTROL
The temperature control is located inside the freezer on
upright models, and on the teft outside wall on chest
modets The temperature control should be factory pre-set
to number 4, which will provide satisfactory food storage
temperatures, However, the temperature control is adjust-
able to provide a range of temperatures for your personal
satisfaction_ If a colder temperature is desired, turn the
temperature control knob to a higher number Adjust by one
numerical increment at a time, and allow several hours for
temperatures to stabilize between adjustments
Loading ...
Loading ...
Loading ...