Loading ...
Loading ...
Loading ...
10
18890 ENGLISH
OPERATION
Stop Bracket/Line Blocker
The stop bracket (A) is set up to automatically
shut down the hoist if the line blocker (B) begins
to pull it upwards. This helps prevent the wire
cable from retracting too far on the spool and
causing any damage to the spool, cable or hoist.
Double Line Operation Cont’d.Double Line Operation Cont’d.
Once the support hook is securely hooked into
the double line support hole and the safety clasp
has been fully clasped, then the pulley hook can
be attached to the wire cable. Please follow these
steps for attaching the pulley hook to the wire
cable.
1. Remove R-pin from the retaining bolt. (A)
2. Pull retaining bolt out of pulley hook, making
sure all washers and hook are captured. (A)
3. Remove the nuts (2) and bolts (2) from the
pulley. (B)
4. Place the pulley hook assembly (without the
hook attached) onto the wire cable below the
line blocker.
5. Make sure the pulley hook roller is aligned on
the wire cable and is not in any way askew or
oblong seated on the wire.
6. Test the alignment of the pulley hook by
sliding it across the wire cable a few inches,
back and forth.
7. Slide the bolts (2) back into the pulley and
secure with nuts (2). (B)
8. Slide retaining pin back through the pulley,
hook and all washers. (A)
9. Replace the R-pin into retaining pin to lock it
in place. (A)
10. Test a small sample load on the pulley hook
to make sure the connection is secure and
pulley roller is aligned. Make sure the load
is directly underneath hoist and is not at an
angle.
If pulley hook roller is not properly aligned
damage to the wire cable or accidental load
dropping could occur.
WARNING
Maintain at least 4 wraps (coils) of cable on
the drum during operation. Operating with
fewer than 4 warps of cable on the drum can
cause the cable to pull off the drum.
WARNING
A
B
BA
Do not try to re-position or remove the line
blocker. It has been preset for safety reasons.
CAUTION
Loading ...
Loading ...
Loading ...