Loading ...
Loading ...
Loading ...
4.3.9 Fitting the lower soft stop damper
Fig. 15
u Loosen cover
Fig. 15 (26)
from the panel
Fig. 15 (20)
and
insert on the other side.
u With the hinge of the soft stop unit facing the door
hinge side, engage the soft stop unit (A) and swivel
inwards (B)
w
The holes on the left and right must lie exactly above
each other
u Tighten soft stop unit (2 x Torx® 15)
Fig. 15 (25)
.
Fig. 16
u Hook panel
Fig. 16 (20)
into the damper bracket such
that the detent hooks are pointing forwards and the
front side is facing the appliance.
u Pull damper bracket
Fig. 16 (24)
towards bearing bracket
and insert bolt
Fig. 16 (23)
from above such that the
square is resting in the recess.
u Position cover
Fig. 16 (21)
and snap in.
w
Check that the cover is positioned correctly such that
the door can close properly and the bolt is secured
u Remove locking device
Fig. 16 (22)
by twisting it.
u Snap panel
Fig. 16 (20)
into place on the door.
u Close the lower door.
4.3.10 Fitting the upper door
u Place the upper door onto the center bearing pin
Fig. 12 (32)
.
u Insert the upper bearing bracket
Fig. 9 (12)
on the new
hinge side into the door.
u Tighten the upper bearing bracket (to 4 Nm)(2 x Torx®
25)
Fig. 9 (13)
. Make preliminary holes (optional) or use
a cordless screwdriver.
u Snap both cover
Fig. 9 (11)
and cover
Fig. 9 (10)
into
place on the opposite side.
u Leave upper door open.
4.3.11 Fitting the upper soft stop damper
Fig. 17
u Loosen cover
Fig. 17 (9)
from the panel
Fig. 17 (1)
and
insert on the other side.
u With the hinge of the upper soft stop unit facing the
door hinge side, engage the soft stop unit (A) and
swivel inwards (B)
w
The holes on the left and right must lie exactly above
each other
u Tighten soft stop unit (2 x Torx® 15)
Fig. 17 (7)
.
Note
u Follow the correct sequence First hang the panel over
the damper bracket, then the cover
Fig. 18
u Hook panel
Fig. 18 (1)
into the damper bracket
Fig. 18 (4)
such that the detent hooks are pointing inwards and the
front side is facing the appliance.
u Push on cover
Fig. 18 (5)
from the outside (A) and pivot
over the bearing part
Fig. 18 (8)
(B).
u Place cover
Fig. 18 (5)
on top and allow to snap into
place until the first notch.
w
The openings for the bolts lie above each other after
positioning the damper bracket
u Pull damper bracket
Fig. 18 (4)
towards bearing bracket
and insert bolt
Fig. 18 (3)
from above such that the
square is resting in the recess.
Start-up
10 * Depending on model and options
Loading ...
Loading ...
Loading ...