Loading ...
Loading ...
Loading ...
7
OPERATING YOUR APPLIANCE
It is recommended you install the appliance in a place where the ambient temperature is between 72º
and
78ºF (23º-26ºC). If the ambient temperature is above or below the recommended temperatures,
the
performance of the unit may be affected. For example, placing your unit in extremely cold or hot
conditions
may cause interior temperatures to fluctuate. The range of 34-50ºF (1-10ºC) may not be
reached.
CONTROL PANEL
Mechanical Control
1.
There is a TEMP-ADJ knob inside the beverage cooler. The temperature in the cabinet can be
adjusted within the range 34-50°F
(1-10°C).
2.
To lower the temperature in the cabinet, turn the TEMP-ADJ knob from left to right (clockwise)
by the indicating black dot on the knob. A setting close to 7 is the coldest, and a setting close
to
1 is the warmest.
3.
When using the appliance for the first time, turn the knob to Coldest or 7 to cool down the
cabinet quickly.
4. The LED light inside is automatically controlled. When you open the door, the light will turn
on
immediately and when you close the door, the light will turn off automatically.
NOTE:
If the unit is unplugged, or power is lost or turned off, you must wait 3 to 5 minutes
before
restarting the unit. If you attempt to restart before this time delay, the unit will
not start.
When you use the unit for the first time or restart the unit after it has been shut off for a
long
time, there could be a few degrees variance between the temperature you select
and the one
indicated on the LED readout. This is normal and is due to the length of the
activation time.
There should not be a problem once the unit has been running for a few
hours.
DOOR LOCK
Your unit is provided with a lock and key combination.
The keys are located inside the plastic bag that contains the User Manual. Insert the key into the lock
and
turn it counterclockwise to unlock the door. To lock the door, do the reverse operation, making
sure the
metal pin is engaged completely. Remove the key and put it in a secure place for safekeeping.
DEFROSTING
This appliance requires no manual defrosting. During the operation of the compressor, ice will build
up on
the evaporator plate which is at the back of inner cabinet. During the compressor’s off-cycle,
the ice will
melt, drip down, and collect in a tray above the compressor, where the compressor’s heat
evaporates the
water. If you notice excessive ice build-up on the evaporator, try setting the
temperature slightly higher.
Also, be sure that the door gasket is sealing well.
SHELVES
The unit has three removable glass shelves. To take out a shelf, first remove its contents,
then
raise the back of the shelf slightly and pull the shelf out.
Loading ...
Loading ...
Loading ...