Loading ...
Loading ...
Loading ...
ELECTRONIC CONTROL SETUP
See the programming guide for information on setup.
MAINTENANCE INSTRUCTIONS
Maintenance instructions:
m Clean lint screen after each cycle.
m Removing accumulated lint:
• From inside the dryer cabinet:
Lint should be removed every 2 years or more often,
depending on dryer usage. Cleaning should be done
by a qualified person.
• From the exhaust vent:
Lint should be removed every 2 years, or more often,
depending on dryer usage.
If dryer does not operate, check the following:
[] Electric supply is connected.
[] Circuit breaker is not tripped or fuse is not blown.
[] Door is closed.
[] Controls are set in a running or "ON" position.
[] Cycle has been selected.
[] Check that gas supply shutoff valves are set in open position.
If you need assistance:
Contact your authorized Maytag Commercial Laundry distributor,
or visit: www.MaytagCommercialLaundry.com. When you call,
you will need the dryer model number and serial number.
Both numbers can be found on the serial-rating plate located
on your appliance.
REVERSINGTHE DOOR SWING (OPTION )
You can change your door swing from a right-side opening to a
left-side opening, if desired.
C
1. Open dryer door. Remove bottom screws from cabinet side of
hinges (A). Loosen (do not remove) top screws from cabinet
side of hinges.
2. Lift door until top screws in cabinet are in large part of
hinge slot. Pull door forward off screws. Remove top
screws from cabinet.
3. Remove screws attaching hinges to door.
4. Remove screws from all sides of door (5 screws). Grasp sides
of outer door and gently lift to separate it from inner door (do
not pry apart). Do not pull on door seat or plastic door catch.
5. Reattach outer door panel to
inner door panel so handle
is on the side where hinges
were just removed.
6. Attach door hinges to dryer door so that the larger hole is
at the bottom of the hinge and the hinge pin is toward the door
front.
7. Remove the 4 screws that attach 2 plugs (B) on the handle
side. Attach plugs to opposite side using the same 4 screws.
8. Insert screws into bottom holes on left
side of cabinet. Tighten screws halfway. _ _1
Position door so large end of door hinge
slot is over screws. Slide door up so
screws are in bottom of slots. Tighten
screws. Insert and tighten top
screws in hinges.
9. Close door and check that door strike aligns with door
catch (C).
10
Loading ...
Loading ...
Loading ...