Loading ...
Loading ...
Loading ...
6
12090 ENGLISH
ASSEMBLY
Contents of the Box
This CPE 2000 lb./5000 lb./6000 lb. utility
winch comes with the wire cable and hook already
attached. The box will also contain the remote
control, battery cables, adapter plate and crank
handle. Please make sure to remove all contents
from the box before assembly or operation.
Mounting the Winch Permanently
This CPE 2000 lb./5000 lb./6000 lb. utility
winch can be securely mounted to a fixed anchor
point before operation. Mounting hardware is
not included. Mounting hardware must be strong
enough to withstand all loads and forces imposed
on it and the winch. Anchor point must also be
strong enough to withstand all forces imposed on
it from the loads and winch.
1. Find a secure and suitable anchor.
2. Using the holes at the bottom of the winch
frame, take a marker and mark “spot” holes
on the anchor.
3. Measure each hole on the winch frame and
choose the correct drill bit for each one.
4. Drill through all “spot” holes in the anchor.
5. Secure winch to anchor through all holes
using rated bolts, washers, and nuts able to
withstand any loads and forces imposed on
them by the loads and winch.
6. Make sure all bolts and nuts are tightened.
Always double check anchor before drilling
to ensure there are no hidden compartments
or panels that may be damaged or cause
structural damage by drilling.
CAUTION
If a mounting channel (not included) is used,
make sure it is rated to take any load weight or
force the winch and loads may impose on it.
NOTE
The length of bolts needed for mounting will
vary based on the thickness of the anchor
used. Measure anchor accordingly.
NOTE
Utility Winch Location
When choosing an anchor (permanent or
temporary) for the utility winch location please
keep these safety points in mind.
– The winch area must not be accessible to
children or animals. Loads may be very heavy
and property damage, injury or death may
occur if distractions are present.
– Make sure the winch is not installed on any
support structure that is located overhead.
– The winch should be located in an area that
has enough clearance on all sides of it, to
avoid any accidental breaking of the wire
cable.
– Do not choose an area where the winch can
or will be submerged in water.
– Do not winch at any angle. Winching at any
angle can damage the wire cable and winch.
Do not use the winch handle to anchor the
winch at any time.
DANGER
Loading ...
Loading ...
Loading ...