Loading ...
Loading ...
Loading ...
Problem Possible Cause Solution
Won't Drain/ Lowvoltage or using Check electrical source or call
Won't Spin/ an extension cord. electrician. Do not use extension
Wet Loads cords.
(cont.)
Cold rinses. Cold rinses leave loads wetter than
warm rinses.This is normal.
Continues Drain hose is less than Raisethe drain hose (see
to Fill/ 39 in (99 cm) above floor. "Installation Requirements").
Continues
to Drain/ Drainhose fits tightly into Adjust drain hosefor loose fit
Cycle Stuck standpipe. (see "Installation Instructions").
Drain hose taped into Donot seal off drain hose with tape.
standpipe. The drain hose needs an air gap,
Washer Makes Load is unbalanced. Redistribute load.
Noise
Washeris not level. Level washer. Reset rear legs
Rear leveling legs not set, (see "Installation Instructions").
Nutson front feet not tight. Tighten nuts (see "Installation
Instructions").
Yellowshipping strap with Remove strap with cotter pins
cotter pins not completely (see "Installation Instructions").
removed.
Floor not strong enough Relocatewasher (see "Installation
to support washer. Requirements").
Gears engaging after drain This isnormal.
andbefore spin.
Upper part of agitator clicks This isnormal.
during wash.
Won't Waterinlet valve Clean screens.
Fill/Won't screens are plugged.
Rinse/Won't
Agitate/ Wateris turned off. Turnon water.
Wrong Hot and cold hoses are Reverse hoses (see "Installation
Temperature reversed. Instructions").
Inlet hose is kinked. Straighten hoses.
Timerdial is not lined up, Turntimer knob to the right slightly
andpull to start.
Power cord not plugged in, Plug into a grounded 3prong outlet.
26
Loading ...
Loading ...
Loading ...