Loading ...
Loading ...
Loading ...
11
High Pressure Pump Oil: The preferred oil is SIMPSON
®
Premium Pump
Crankcase Oil. If this oil is not available, an SAE 15W-40 oil may be used. Change
the pump oil after the first 50hours of operation and every 100 hours thereafter, or
every 3 months.
Gasoline Engine Oil:
Check engine oil level before each use. Refer to the
Engine
Owner's Manual
for correct procedure.
12V DC Battery:
The 12V DC battery operates the engine's electrical start system,
after the engine is started the system will charge the battery and operate the burner.
The 12V battery will need to be replaced regularly to ensure consistent performance.
Recommended battery size:
Group 24 battery
Burner Assembly: A device used to change fuel to heat energy. It is used to heat
the water in the coil assembly and is designed to use a NO. #2 diesel fuel.
BTU (British Thermal Unit): The amount of time it takes to raise the temperature
of one pound of water by one degree Fahrenheit.
Temperature Control: The burner system is equipped with an adjustable
temperature control. See Specification Insert for maximum temperature for each
unit. Do not set thermostat above 195°F. The burner will shut off if insufficient water
flow through the burner's heater coil causes the outlet water temperature to be
excessive.
Back Flow Preventer: Prevents backflow into a potable water system.
WARNING: To reduce the possibility of contamination always protect
against backflow when connected to a potable water system
Pressure Switch: A switch which uses a pressure activated plunger to activate a
microswitch, used to control the fuel solenoid in the burner system.
Flow Switch: A switch which responds to changes in water flow, water flow
moves a magnet which ativates a reed or microswitch to control voltage to the fuel
solenoid in the burner system.
Chemical Injection System: Mixes cleaners or cleaning solvents with the water to
improve cleaning effectiveness.
High Pressure Hose: Only use a wire braid hose rated for the output pressure and
temperature of the high pressure pump. See Specification Insert for the maximum
temperature. Additional hose lengths can be added with quick twist couplers with
a minimal loss in pressure of about .5 PSI per foot. Always inspect hoses for wear
and replace if necessary. Avoid kinking or running over the hose to extend the
hoselife.
Hour meter: The analog hour meter operates whenever the engine is running and
keeps track of how many hours the unit has been used.
Water Supply: The minimum requirements for a water supply are 20 psi and 5
Water Supply: The minimum requirements for a water supply are 20 psi at twice
the stated water volume for the machine. If your water source is a well, the garden
hose length can only be 30ft. (9m) maximum.
EVAP canister: Collects fuel vapors and later purges them so they burn in the
combustion process.
Loading ...
Loading ...
Loading ...