Loading ...
Loading ...
Loading ...
26
CARE AND CLEANING
To clean the surface burner heads:
For proper gas flow, it may be necessary to clean the
burner ports. Before cleaning be sure the gas burners are
turned off. First use a clean DAMP cloth to soak up any
spills. Remove any food from the burner ports using a small
non-abrasive brush like a toothbrush, and afterwards wipe
up using a damp cloth. For stubborn soils located in the
burner ports, use a small gauge wire or needle to clean.
Any spill on or around the igniter must be carefully cleaned.
Take care not to hit the igniter with any thing hard, or it
could be damaged.
Removing and replacing surface burners
To remove burners:
1. Remove the shipping screws with a Phillips Head
screwdriver. See
Figure 14 for screw locations.
2. Tilt the burner at the end closest to the support bar until
the locator tab is released (front burners tilt right, rear
burners tilt left). Move the burner towards the back of
the range. This will separate it from the gas valve at the
front of the range.
To replace burners:
1. Slide the burner tube over the gas valve at the front of
the range (front burners fit over the right valve, rear
burners fit over the left valve on each side of the range).
2. Tilt burner so that the locating tab will slide into the slot
on the support bar. Make sure burners are properly
seated on support bar and are level.
3. Replace the shipping screws.
Cleaning under cooktop
To raise the cooktop for cleaning:
1. Remove burner grates when cool from cooktop and set
aside.
2. Grasp the sides of the cooktop and then lift from the
front (see
Figure 15).
3. Lift the top high enough to allow the support rods to
snap into place. The lift-up rods will support the cooktop
in the raised position.
4. If necessary, clean underneath using hot, soapy water
and a clean cloth; then, dry.
5. To lower the cooktop, grasp the front corner of each
side of the top while pushing back on each rod with the
heel of your hand. This will release the notched support.
Hold the range top and gently slide the range top down
to the range.
Figure 14: Burner shipping screws
Figure 15: Raise cooktop
DO NOT turn the burners on when the cooktop is
raised for cleaning. Be sure that the top is
completely lowered and securely in place before
turning on the surface burners.
When lowering the lift-up range cooktop, grasp the sides
with finger-tips only. Be careful not to pinch fingers. Do
not drop or bend the range cooktop when raising or
lowering. This could damage the cooktop surface.
cooktop
support rods
WARNING
CAUTION
Loading ...
Loading ...
Loading ...