Loading ...
Loading ...
Loading ...
Youcancustomizeyourcyclebyselectinganoption.
Seeoptionselections.Ifyouchangeyourmind,presstheoptionagaintoturnofftheoption,orselectadifferentoption.Youcanchange
anoptionanytimebeforetheselectedoptionbegins.
*Maximumwashtimesdependonwatertemperature,heavysoilcondition,dishloadsizeandoptionsselected.
OPTIONS DISH LOAD TYPES DESCRIPTIONS USE WITH:
I_ ............................_'_ Pansl casseiOles, etcl With ACtivates the PROSCRUB® spraY jets and provides Heavy Duty or Normal
ProScrub tough food soil, intensified water spray to the back of the !ower !evel rack. cycle
!_...............................J May add heat and time to the cycle.
To sanitize your dishes and
glassware in accordance
with NSF/ANSI Standard
184 for Residential
Dishwashers.
Raises the water temperature in the final rinse to
approximately 155°F (68°C). This high temperature rinse
sanitizes your dishes and glassware in accordance with
NSF/ANSI Standard 184 for Residential Dishwashers.
Certified residential dishwashers are not intended for
licensed food establishments.
The Sanitize or Sani Rinse option adds heat and time to the
cycle.
Normal cycle. Heavy
Duty cycle automatically
uses Sani Rinse. Only
these sanitization cycles
have been designed to
meet the NSF/ANSI
requirements.
......................._ Loads containing tough increases the target water temperature during the Wash HeaVY Duty or Normai
Hi-Temp baked,on food. portions of the cyclei cycles
Scrub
" ..............................._ Adds heat, wash time and water to the cyc!e,
For best drying results, dry
dishes with heat.
Turn OFF when loads contain plastic dinnerware that may be
sensitive to high temperatures.
This option with the use of rinse aid will provide the best
drying performance.
All cycles, except Rinse
Only. Automatic with all
wash cycles unless you
turn it off.
jO_........................To run your dishWasher at Delays the start of a cycle up to 4 hoUrsl All CYc!esl except Rinse
4Hour a later time or dunng off On y
Delay , ," .... select a Wash cYcle and options: Press 4 HoUr De!aYI Press ........
j peak nours
_,,,....................... " START/RESUME. Close the door firmly.
Control Lock To avoid unintended use of To turn on Lock, press and hold Heat Dry for at least Anytime
your dishwasher, or cycle 4 seconds.
and option changes during
a cycle.
To turn off Lock, press and hold Heat Dry for at least
4 seconds.
When Control Lock is lit, all buttons are disabled. Ifyou press
any pad while your dishwasher is locked, the light flashes
3 times. The dishwasher door can be opened while the
controls are locked.
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the
cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle
will automatically compensate by adding time, heat and water as needed.
CONTROL PURPOSE COMMENTS
To start or resume a If the door is OPened during a cYCe orthe power is interrupted, the START/RESUME indicator
wash cycle flashes. The cYCle will not resume until the door is closed and START/RESUME is pressed,
NOTE: If the START/RESUME button is located ontop of door, push door firmly closed Within
3 seconds of pressing START/RESUME,
To cancel wash
cycle
Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
drain completely.
® Was,,ng TOfollow the The Clean indicator glows When a Cycle is finished.
O Dry ng progress of your
• fYoUseecttheSan Rinse oPt on; when the san ainsecYceisfinshed, theSantzed ndicator
Clean d snwasner cyc e
<a_t_ed glows. If your dishwasher did not proper y sanitize your dishes, the light f ashes at the end of the
. v: cycle This can happen if the cycle is interrupted, or the water could not be heated to the required
.................. temperature. The light goes off when you open and close the door or press CANCELI
Loading ...
Loading ...
Loading ...