Loading ...
Loading ...
Loading ...
9
Programming Pads
Oven is shipped from the factory for single pad programming. To change the
oven default to allow double pad programming, see
User Option
section. To
change the amount of time or the power level for a preset pad:
1. Open oven door.
• READY displays.
• If door is closed or STOP/RESET pad is pressed before programming
is complete, changes are discarded and microwave exits
programming mode.
2. Press and hold pad 1 for approximately 5 seconds.
• This begins programming mode.
• Microwave will beep and
PROGRAM displays. Oven is in programming
mode.
3. Press pad to be reprogrammed.
• Press two pads if reprogramming a double pad program.
• Power level and cooking time display.
• If power level does not display, microwave is set to full power.
4. Enter cooking time by using the number pads.
5. Press a power level pad to change power level if desired.
6. Enter cook time and power level as in steps 4 and 5 (some models)
• To enter another cooking stage for that pad, press TIME ENTRY pad
again.
• Up to four different stages can be programmed (some
models).
7. Press START pad to set new programming changes to the
pad.
• PROGRAM displays.
• If START is not pressed, changes will not be saved.
8. Press STOP/RESET pad or close oven door to exit programming mode.
Programming the Oven Control (Electronic Control)
Programming Multiple Stages (some models)
Stage cooking allows consecutive cooking cycles without interruption.
Up to four different cooking cycles can be programmed into a memory pad.
To use stage cooking:
1. Follow steps 1 through 5 above (Programming Pads).
6. Press TIME ENTRY pad.
• Display briefly shows the pad number that is being
programmed and the stage number to the upper right.
• Display changes to cook time and power level for the next stage.
7. Enter cook time and power level as in steps 4 and 5 above
(Programming Pads).
• To enter another cooking stage for that pad, press TIME
ENTRY pad again.
• Up to four different stages can be programmed.
8. Press START pad to set new programming changes to the pad.
9. Press STOP/RESET pad or close oven door to exit programming
mode.
The display shows
PROGRAMPROGRAM
PROGRAMPROGRAM
PROGRAM.
When set to single pad or
double pad programming, the display
will show
PROGRAM when
programming pads for single or double
digit cooking sequenses. To change
the oven’s default to allow either
single pad or double pad
programming, see the
User Option
section.
QTY 2X
Programming
(some models)
This feature allows a preset
percentage of original cook time,
called a cooking factor, to be added to
a cook sequence.
To change the cooking factor:
1. Open oven door.
2. Press and hold pad 1 for
approximately 5 seconds.
3. Press pad to be reprogrammed.
4. Press the QTY 2X pad.
5. Press a numbered pad to change
the cooking factor.
• Cooking factor can be set from
10% to 100%.
• Default is 80%.
• Pad 5 would change the
cooking factor to 50%.
• Pad 3 would change the
cooking factor to 30%.
6. Press START pad to save changes.
Canceling Mistakes
If oven is not cooking, press
STOP/RESET pad to clear
display. If oven is cooking, press
STOP/RESET pad once to stop oven,
then again to clear display. If oven
door is open and time shows in
display, close oven door and press
STOP/RESET pad to clear display.
Loading ...
Loading ...
Loading ...