Loading ...
Loading ...
Loading ...
- 4 -
INSTALLATION AND GROUNDING INSTRUCTIONS
Examine Your Oven
Unpack oven, remove all packing material, and examine the
oven for any damage such as dents, broken door latches
or cracks in the door. Notify dealer immediately if oven is
damaged. DO NOT install if oven is damaged.
Remove Protective Plastic Film
If a plastic film has been wrapped around the oven to protect
the painted finish from scratching during shipping, please
remove this plastic film prior to using the oven. (However, all
ovens do not have plastic film wrapping.)
Placement of Oven
1. Oven must be placed on a flat, stable surface. For proper
operation, the oven must have sufficient air flow. Allow
3-inches of space on both sides of the oven and 1-inch of
space on top of oven.
a. DO NOT block air vents. If they are blocked during
operation, the oven may overheat. If the oven overheats,
a thermal safety device will turn the oven off. The oven will
remain inoperable until it has cooled.
b. DO NOT place oven near a hot damp surface such as a
gas or electric range.
c. DO NOT operate oven when room humidity is too high.
Grounding Instructions
This appliance must be grounded. In the event of an electrical
short circuit, grounding reduces the risk of electric shock by
providing an escape wire for the electric current. This appliance
is equipped with a cord having a grounding wire with a
grounding plug. The plug must be plugged into an outlet that is
properly installed and grounded.
WARNING
-
Improper use of the grounding plug can result in
a risk of electric shock.
Consult a qualified electrician or service person if the grounding
instructions are not completely understood, or if doubt exists as
to whether the appliance is properly grounded.
If it is necessary to use an extension cord, use only a three wire
extension cord that has a three blade grounding plug, and a
three slot receptacle that will accept the plug on the appliance.
The marked rating of the extension cord should be equal to or
greater than the electrical rating of the appliance.
Wiring Requirements
1. The oven must be plugged into at least a 15 AMP 120
VOLT, 60 Hz GROUNDED OUTLET.
Where a standard two-prong outlet is encountered, it is the
personal responsibility and obligation of the user to have it
replaced with a properly grounded three-prong outlet
(Fig. 1 ).
Fig. 1
2. The oven must be on a SEPARATE CIRCUIT. No other
appliance should share the circuit with the microwave oven.
If it does, the branch circuit fuse may blow, or the circuit
breaker may trip or the food may cook slower than the times
recommended in this manual.
3. The Voltage used must be the same as specified on
this microwave oven (120 V). Using a higher Voltage
is dangerous and may result in a fire or other accident
causing oven damage. Using a lower Voltage will cause
slow heating. Panasonic is NOT responsible for damage
resulting from the use of the oven with other than specified
Voltage.
F0003BS70AP_Eng_11_20150326.indd 4F0003BS70AP_Eng_11_20150326.indd 4 2015/3/26 8:57:112015/3/26 8:57:11
Loading ...
Loading ...
Loading ...