Loading ...
Loading ...
Loading ...
NOTE: Use 2 hands to install filter, one to pull and turn the knob,
the other to hold the filter in place so that it doesn't fall.
1. Insert back edge of filter into rear channel of the filter
opening.
2. Pull out on knob and turn counterclockwise, position front
edge into place and release knob.
3. Repeat for remaining filters.
1=
2.
( , 'I :>'[l_i .......................
Check operation of the range hood by turning on the power.
The range hood controls are located on the right-hand
underside of the range hood.
3. Move the light switch to "1" position. The lights should turn
on.
4. Move blower switch to "1" position. The blower should
operate.
5. Move the blower speed switch to "1" position for low speed,
"2" position for medium speed or "3" position for high speed.
6. Move blower and light switches to "0" position to turn blower
and light off.
7. If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
Disconnect power supply and check that the wiring is
correct.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.
A. Controls
B. Filters
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
The hood controls are located on the right-hand underside of the
range hood.
2. Move the light switch to the "0" position to turn range hood
light OFR
Operating the blower
1. Move the blower switch to the "1" position to turn the blower
ON. The blower will begin operating at the speed set on the
blower speed switch.
2. Move the blower switch to the "0" position to turn the blower
OFR
Adjusting the blower
The blower has 3 speed controls. Move the blower speed switch
to "1" position for low speed, "2" position for medium speed or
"3" position for high speed.
B C D
A. Controls
B. Light switch
C. Blower switch
D. Blower speed switch
Operating the light
1. Move the light switch to the "1" position to turn range hood
light ON.
Operating the heat lamp (optional accessory)
1. Install heat lamp bulbs (not included) into heat lamp sockets.
NOTE: Heat lamp bulbs should be rated to a maximum of
250 watts each.
Food Poisoning Hazard
Do not let food sit for more than one hour before or
after cooking.
Doing so can result in food poisoning or sickness.
2=
To turn on a light, move the switch in the heat lamp panel
closest to the desired light into the "1" position. Move the
switch into the "0" position to turn off the light. Repeat with
the other light.
11
Loading ...
Loading ...
Loading ...