Loading ...
Loading ...
Loading ...
1
GETTING STARTED
Safe and satisfactory operation of the Teppanyaki Griddle depends upon its proper installation. The installation,
adjustments and service of the Griddle must be performed only by a qualified installer and service technician.
Proper location and proper use is essential to insure safe and continued trouble-free operation. Any alterations
made to the appliance will void the product’s warranty.
Before installing, check the rating/serial plate of the Teppanyaki Griddle. Use only the electrical power supply
and type of gas supply (natural or propane) as specified on the rating/serial plate. This information is found on
the serial plate, located on the inside wall of the left hand side panel.
Electrical Specification
The appliance should only be taken apart be a qualified technician, or electrical shock may occur. It is rated
at 120V, 60Hz, 900W and 8A.
Propane or LP
If your Teppanyaki Griddle is factory built for LP, the regulator supplied is set to 11 in wc (2.74 kPa) and is
for use with LP gas only. The factory supplied regulator and hose must be used with a 20 lb LP cylinder. Do
not use any replacement regulator other than that specified be Twin Eagles.
Natural Gas or NG
If the Teppanyaki Griddle is factory built for natural gas, the regulator supplied is set for 4” water column.
No not use any replacement regulator other than that specified by Twin Eagles.
Shipment
This Teppanyaki Griddle is inspected before leaving the factory. The shipping carrier assumes full
responsibility for the safe delivery of the appliance. Check for possible shipping damage immediately after
unpacking. If the Breakfast Club is found to be damaged, save the packaging material and contact the
shipping carrier immediately.
Unpacking
Remove all packaging materials, labels and protective plastic film. DO NOT LEAVE UNIT UNDER THE
SUN WITH PROTECTIVE FILM ON FOR AN EXTENDED PERIOD OF TIME AS IT WILL BE
DIFFICULT TO REMOVE THE FILM.
Loading ...
Loading ...
Loading ...