Loading ...
Loading ...
Loading ...
OPERATION
Moving Machine By Hand
When pushing or pulling the mower, engage the IZT
(integrated Zeroturn Transaxle) bypass linkages. The
release levers are located on each side of the rear of
the unit below the rear engine plate.
1. Raise the deck to the highest (transport) position.
2. Pull the release levers up and out of the keyhole
slots. Release the levers with the head outside the
bracket and held into the bypass setting.
3. To reengage the IZTs to drive, reverse the above
procedure.
Load the machine into truck or trailer by driving up
ramps in low gear. DO NOT LIFT! The machine is not
intended to be lifted by hand.
WARNINGt
Use extreme caution when loading the
machine into a truck or trailer using
ramps. There is the possibility of serious
injury or death if the machine falls off the
ramps.
1, IZT locked into the bypass position
2, Linkage lever, engaged
Right side, IZT linkage
8058-059
WARNINGt
Make no adjustments without:
• the engine stopped,
• the ignition key removed,
• the parking brake activated
WARNINGt
Bypass linkages are located close to the
muffler. To prevent burns, the engine
should be shut off and allowed to cool
before the bypass linkage levers are
handled.
34
Loading ...
Loading ...
Loading ...