Loading ...
Loading ...
Loading ...
5
INSTALLATION INSTRUCTIONS
IMPORTANT: After transit where the cooler has been on its side or back, ensure that the cooler is
in a level, upright position for 12 hours before connecting the appliance to a power source, this will
reduce the possibility of a malfunction in the cooling system from handling during transportation..
UNPACKING AND CLEANING
Remove all packaging and securing tapes from the appliance. To avoid injury and causing dam-
age to the appliance, be extremely cautious when using sharp or pointed tools to complete this
task. Keep children away from the packaging material - DANGER OF SUFFOCATION! Wash the
inside and outside of the appliance with luke warm water and a mild soap or detergent. Abrasive
or corrosive cleaning agents, steel wool, scouring sponges, or chemical cleaning agents should
not be used under any circumstances. A sponge, soft brush or towel is recommended. After clean-
ing, thoroughly rinse and dry. You may want to leave the doors open allowing the compartments
to ventilate for 20-30 minutes to get rid of residual odors. Check with your local Environmental
Agency for recommendations on recycling packaging materials in your area.
POSITIONING THE APPLIANCE
The area in which the cooler is to be installed must be relatively cool, dry, and suitably ventilated.
The area must be protected against any inclement weather (rain, snow) and excessive surface dust.
To ensure proper function, the appliance must be placed on a at, rm, and stable surface resting
level on all four supports. The oor must be strong enough to support a fully loaded cabinet. Use
wood or metal shims to level the cooler if necessary. Do not place the appliance in direct sunlight
or near sources of heat, such as a stove or heater, as this can increase electrical consumption and
decrease performance. Extreme cold ambient temperatures may also cause the appliance to per-
form improperly.
This appliance uses the exterior walls to transfer heat from the inside of the cabinet. Ensure that
there is adequate space between the cooler and neighboring walls or large objects. A minimum
spacing of 3 inches (7.6 cm) is highly recommended. This will provide suf cient air ow around
the appliance resulting in more ef cient operation and longer appliance lifetime. Always keep the
air vent openings of the compressor housing cover free from dust and obstructions.
Loading ...
Loading ...
Loading ...