Loading ...
Loading ...
Loading ...
ASSEMBLY INSTRUCTIONS (continued)
ASSEMBLY INSTRUCTIONS (continued)
Manual
Override
Manual Override Operation Diagram
Turn wall switch OFF-ON
in 1~3 Seconds
Fig. 2
Fig. 1
(View from bottom of back plate)
SECURITY
Mode
FUNCTION AND OPERATION (continued)
DUSK/DAWN SECURITY
TIME
SENSITIVITY
TEST
Fig. 3
Coverage Dial
Moderate View Angle
Maximum View Angle
No View Angle
Lens
Slot
Turn off the wall switch,
and after 5 seconds
turn it on.
Customization Options
Shut-off Delay
The Shut-off delay is the length of time the light will stay on after motion has ceased to be detected.
This Shut-off delay can be set when operation is in “SECURITY” mode by using the “TEST/TIME” knob located on the
bottom of the back plate (See Fig.1) . To increase the shut-off delay, turn the knob clockwise. To decrease shut off delay,
turn the knob counterclockwise. The delay may be adjusted from a minimum of 5 seconds to a maximum of 10 minutes.
The light will stay on as long as motion is detected continuously and will automatically turn off when no more motion is
detected after the delay time has passed.
Sensitivity of Motion Sensor
The sensitivity of the motion sensor can be adjusted by using the “SENSITIVITY” knob located on the bottom of the back
plate (See Fig.1). To increase sensitivity, turn the knob clockwise. To decrease sensitivity, turn the knob counterclockwise.
The sensitivity may be adjusted from a minimum of 5 feet to a maximum of 30 feet.
Adjust The View Angle of Motion Sensor
Rotate the mode selector knob to “SECURITY”, and rotate “TEST/TIME” knob arrow to point to “TEST” (See Fig.1), walk
in the tested area, when the motion is detected, the light is came on, move to another tested spot, do the same action to
check the coverage area of motion detector. There are two coverage dials in the left and right of the lens.
When the slot in the coverage dial is aligned to “ ” (no view angle), the built-in detector is covered, the light does not
have motion sensor function.
When the slot in the coverage dial is aligned to “ ” (moderate view angle), the built-in detector is covered a portion, the
view angle is reduced.
When the slot in the coverage dial is aligned to “ ” (maximum view angle), the built-in detector is not covered, the
view angle is maximum.
Rotate either side of the left or right coverage dial or both side of coverage dials to choose desired view angle (See Fig.3).
NOTE:
1. The sensitivity of the motion sensor will increase as the
environmental temperature gets cooler. For best performance,
gently clean the lens with a soft cloth every 1 or 2 months to
assure maximum sensitivity.
2. For best performance, install fixture at least 6 feet above
the ground. At such a height, the fixture will provide a detection
distance of up to 30 feet at 77 degrees Fahrenheit. (See Fig.4)
3.The sensor detects across a detection range of 180 degrees.
(See Fig.5)
4. The sensor will be more sensitive to motion across its detection
path than motion directly towards it. (See Fig.6)
5. To reduce possible nuisances, do not mount the fixture near a
heat source like an air conditioner, vent or furnace exhaust, or in
a direction facing any reflecting object or other light source.
5`
6`
8`
30`
Where you install your lantern is important:
Be sure the light is mounted straight on the wall;
otherwise, the detection distance may be limited.
Fig. 4 Fig. 5
180˚
Motion
Least sensitive
Motion
Most sensitive
Sensor
Fig. 6
Page 4 of 6
200818
Loading ...
Loading ...