Loading ...
Loading ...
Loading ...
First Steps continued
I__ To allow door to
close and seal properly, DO NOT let
food packages extend past the front
of sheJves.
Shelf Front
DOOR REMOVAL (UPRIGHTMODELS)
If door must be removed, (UNPLUG THE UNIT.)
1. Gently lay freezer on its back, on a rug or blanket.
2. Remove two base screws and base Base
panel. Remove wire from clips on Panel
bottom of cabinet. (Figure 1)
3. Unplug connector by holding the
cabinet connector in place, and
pulling door connector out, if
required. (Figure 1)
4. Remove bottom hinge screws.
(Figure 1)
5. Remove plastic top hinge cover.
6. Remove screws from top hinge.
7. Remove top hinge from cabinet.
8. Remove door and bottom hinge
from cabinet.
9. To replace door, reverse the above
order and securely tighten all screws
to prevent hinge slippage.
-- Base Panel Screws
Hinge Screws
Figure 1
Wire
Cabinet Connector
Setting the
Temperature Control
Cold Control
Cool Down Period
• For safe food storage, allow 4 hours for freezer to cool down completely. The freezer
will run continuously for the first several hours. Foods that are already frozen may be
placed in freezer after the first few hours of operation. Unfrozen foods should NOT
be loaded into freezer until freezer has operated for 4 hours.
• When loading freezer, freeze only 3pounds of fresh food per cubic foot of freezer space
at one time. Distribute packages to be frozen evenly throughout the freezer. It is not
necessary to turn control knob to a colder setting while freezing food.
Temperature Control
The temperature control is located inside the freezer. The temperature is factory preset
to provide satisfactory food storage temperatures. However, the temperature control is
adjustable to provide a range of temperatures for your personal satisfaction. If a colder
temperature is desired, turn the temperature control knob toward COLDEST and allow
several hours for temperatures to stabilize between adjustments.
Freezer Optional
Features
Figure 1
Temp Alarm - Upright Freezers
NOTE
Yourfreezer mayhave some,or all ofthefeatures listed below.Becomefamiliarwith these
features, and theiruse and care.
Power On Light
The Power On Light indicates that the freezer is properly connected to electrical power.
The light glows even when the temperature control is turned to OFF. If the light goes
out, refer to "Freezer does not run" in the Avoid Service Checklist.
TempAlarm
This feature is designed to provide a warning of a possible malfunction. If the
temperature of the food rises to a level unsafe for long-term storage, the buzzer will
sound. The red light, if equipped, will also glow. The Temp Alarm feature operates on
household electricity. Ifpower fails, the alarm wilt not function. An ON/OFF switch allows
you to deactivate the Temp Alarm when not wanted. The freezer is shipped with the Temp
Alarm in the OFF position. After freezer has run approximately 4 hours, the red light, if
equipped, will go off. Then you may activate the Temp Alarm without the alarm sounding.
Press the ON switch to activate the Temp Alarm. To deactivate, press the OFF switch.
If the alarm sounds, be sure freezer is properly leveled, and the door closes freely and
seals properly. If you suspect a technical malfunction, call an authorized servicer
immediately.
4
Loading ...
Loading ...
Loading ...