Loading ...
Loading ...
Loading ...
Operation
Starting the Engine
WARNING! Read, understand and follow all
instructions and warnings on the machine and in
this manual before operating.
WARNING! Wear leather work gloves, safety shoes,
and safety glasses when operating a log splitter.
Ensure safe footing.
Before EachUse
1. With the spark plug wire disconnected, remove the dipstick
and check the hydraulic fluid level. Refill if necessary.
Approved fluids include Shell Tellus®32 Hydraulic Fluid,
Dexron ®III/ Mercon ®automatic transmission fluid,
Pro-SelectTM AW-32 Hydraulic Oil or 10WAW-ISOviscosity
grade 32 hydraulic oil. Check the engine oil level. Refill if
necessary.
2. Fill up the gasoline if necessary.
3. Lubricate the beam area where the splitting wedge will
slide with engine oil. Do not use grease to lubricate. Make
sure to lubricate both the front and back of the beam face.
4. Attach the spark plug wire to the spark plug.
Starting Engine
1. Attach the spark plug wire to the spark plug. Make certain
the metal cap on the end of the spark plug wire is fastened
securely over the metal tip of the spark plug.
2. Turn the fuel valve or the engine switch (if equipped) to the
ON position.
3. Move the choke control (if equipped) to the CHOKE
position.
4. If the engine is equipped with a primer, follow the
instructions in the Engine Operator's Manual to prime it.
5. Turn the throttle control (if equipped) to the FASTposition.
6. Grasp the starter handle and pull the rope out slowly until
the engine reaches the start of the compression cycle (the
rope will pull slightly harder at this point).
7. Pull the rope with a rapid, full arm stroke. Keep a firm
grip on the starter handle and let the rope rewind slowly.
Repeat until the engine cranks.
8. After the engine starts, move the choke control (if
equipped) to the OFFposition. Place the throttle lever at
the desired speed.
In cold weather, run the wedge up or down the beam 6 to 8
times to circulate the hydraulic fluid.
WARNING! When starting a warm engine, the
muffler and surrounding areas are hot and can
cause a burn. Do not touch these areas.
Stopping the Engine
1. Move the throttle control (if equipped) to the STOPor OFF
position.
2. Turn off the engine switch, if so equipped.
Usingthe Log Splitter
2.
3.
4_
f
Place the log splitter on dry level ground and shut offthe
engine.
Block the front and back of both wheels.
Place the beam in either the horizontal or vertical position
and lock in place with the appropriate locking rod.
NOTE:Takeextra care when raising and lowering the beam
as it is fairly heavy. Be sure to keep hands away from any
possible pinch points.
To place the beam in the Vertical Position proceed as
follows:
a. Pull the horizontal beam lock out to release the
beam and pivot the beam to the vertical position.
b. To lock the beam in the vertical position, pull out
on the vertical beam lock and rotate it to secure the
beam. See Fig. 5-1.
i i
Figure S-1
11
Loading ...
Loading ...
Loading ...