Loading ...
Loading ...
Loading ...
8
1886
Installing the Glass
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
Notch
Tab
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Assembling the Light Kit
Align the keyhole slots in the top of the light kit
assembly with the partially installed assembly
screws. Rotate the keyhole slots around the screws
and twist counterclockwise. Install the third light
kit screw. Tighten all three screws securely.
Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
2 of 3
Light Kit Screw
BAG
1 of 3
Light Kit Screw
BAG
Raise cap to the LED assembly. Align the
notches on the sides of the cap with the
screw holes in the LED assembly. Install
the two light cap screws which can be
found in the
hardware bag.
Connect the single-pin connectors from the
LED assembly to the connectors from the fan.
Connect the white wires together. Connect the
blue and black wires together.
2 of 2
Light Cap Screw
BAG
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light LED/Glass Remote
WARNING
FAN FALL HAZARD
Make sure screws are tight to secure the
light xture.
ON
Turn P
ower
Loading ...
Loading ...
Loading ...