Loading ...
Loading ...
Loading ...
10 – English
General
WARNING! Prevent unintentional
starting by removing the ignition cable
from the spark plug.
CAUTION! This lawn mower is shipped without oil or
gasoline in the engine.
Remove the lawn mower from the
carton
• Remove loose parts included with mower.
• Cut down two end corners of carton and lay end panel
down flat.
• Remove all packing materials, except padding
between upper and lower handle and padding holding
the engine brake handle to upper handle.
• Roll the lawn mower out of the carton and make sure
that no loose parts are left within the carton.
Handle
CAUTION! Take care not to damage the cables and
wires when you unfold the handlebar.
Operating position
1. Raise the lower handle section to operating
position. Align the handle bar pins with a slot in the
handle bracket to set a comfortable height position
for the handle.
2. Tighten the lower handlebar knobs.
3. Remove protective padding, raise the upper handle
section into place on the lower handle and tighten
both upper knobs.
4. Remove any packing material from around engine
brake handle.
Install the electric start module
1. Loosen the wing screw.
2. Fully retract the wing screw into the start module
housing (the screw is retained in the housing and
cannot be removed completely).
3. Place the starter module over the upper handle
tube and line up the mounting hole for the wing
screw.
4. Push the wing screw through the mounting hole.
5. Tighten the wing screw against the start module
housing.
6. Connect the wiring harness from the mower to the
pigtail on the electric start module tightly.
IMPORTANT: Make sure the ratcheting lock feature on
the wing screw is engaged to prevent the screw from
loosening during operation.
ASSEMBLING AND ADJUSTMENTS
Loading ...
Loading ...
Loading ...