Loading ...
Loading ...
Loading ...
English 14
Electrical Installation
CAUTION: Installation work and electrical wiring must
be done by qualifi ed person(s) in accordance with all
applicable codes and standards, including fi re-rated
construction.
CAUTION: Before installing, turn off power supply
at the service panel. Lock service panel to prevent
power from being turned on accidentally.
1. Perform the electrical connection as follow: Using UL
approved wire nuts, connect BLACK wire from house
wiring to BLACK wire from hood connector, WHITE wire
from house wiring to WHITE wire from hood connector
and GREEN or bare ground wire from house wiring to
GREEN wire from hood connector. Then, remove and set
aside the screw shown in illustration below for later use.
2. Reassemble the top section of the electrical cover to the
hood shell using its 2 retaining screws.
GREEN to
GROUND
WHITE to
WHITE
BLACK to
BLACK
Hood
Connector
Remove
this screw
Screws
3. Remove and set aside the fi lters from the module and
frame assembly
by opening the latch and fold down the
metal grease fi lter. Simultaneously use your other hand to
grasp under the metal grease fi lter and remove from the frame
assembly.
4. Assemble the module and frame assembly to the hood
shell; align the keyhole slots to the 3 remaining screws
located on the module and frame support. Slide until the
screws are engaged in the small part of the keyholes (see
left insets). Put back in place the screw removed in step 1,
then tighten the 3 remaining screws in order to secure the
module and frame assembly to the hood.
5. Connect the hood connector to its connector (darker grey
part in illustration below).
Align Slide
INSTALLATION
Loading ...
Loading ...
Loading ...