Loading ...
Loading ...
Loading ...
Electrical Connections
2.
3.
Connect disposer to 110-120 Volt, 60Hz
AC current only.
If plug-in cord is used, use a three prong
plug (see A). Ground wire should be
attached to the ground screw in the
bottom of the end bell (see B).
Use a cable clamp strain relief connector
where power cord enter the disposer (see
C).
Tra_;_lea_coHnected_othisbla_!e A
Attaching
Mount Assembly
A. Connect waste elbow to the disposer (see
A), proceed to set B and C then connect
bottom of the elbow by tightening the slip
nut (see D). If you are connecting to a
dishwasher, return to section (B) page 7.
If not, make sure all plumbing connections
are tight and in accordance with all
plumbing codes and ordinances Run
water and check for leaks.
B.
C.
Wiring Disposer Directly to House
Current
This appliance must be connected to a
grounded, metal permanent wiring system or
an equipment grounding conductor must be
ran with the circuit conductors and connected
to the equipment-grounding terminator or lead
on the appliance.
A. If you use BX cable:
1. Install cable connector in hole.
2. Connect white wire to white lead of
disposer.
3. Connect black.
4. Connect bare groud.
If BX cable is not used, provide a separate
ground wire to nearest cold water metal pipe
or other suitable ground, using the screw in
the bottom of the end bell for the ground wire
(see C).
B. If your power supply does not include a
ground wire, you must provide one unless
metal cable is used. Attach a copper wire
securely to disposer ground screw and attach
other end of wire to a metal cold water pipe.
Use only UL approved ground clamp. If
plastic pipe is used in your home, a qualified
electrician should install a proper gound.
Discharge Elbow/Connecting
k
Hang disposer by aligning 3 mounting
tabs with slide-up ramps on mounting
ring.
Turn mounting ring until all 3 mounting
tabs lock over the rides on the slide-up
Disposer to
8
NU_H LC_t#ER
CU_HIONl_,4otl_iTl[t6
D ΒΈ
ramps.
10
Loading ...
Loading ...
Loading ...