Loading ...
Loading ...
Loading ...
Fig. 20
u
Position the handle on the other side.
Fig. 20 (1)
w
The screw holes must be exactly above each other.
u
Tighten the screws with the T15 screwdriver.
Fig. 20 (2)
u
Position the covers on the side and push in.
Fig. 20 (3)
w
Ensure that it clicks into place.
4.3.7 Fitting the door
For all appliances:*
Fig. 21
u
Place the door on the lower bearing pins.
u
Align the top of the door with opening in the bearing bracket.
Fig. 21 (1)
u
Insert the bolt and tighten with a T15 screwdriver.
Fig. 21 (2)
u
Fit the protective cover to protect the door: Insert the protec-
tive cover and check that it is attached to the door. If not,
insert the bolt fully.
Fig. 21 (3)
u
Insert the plugs.
Fig. 21 (4)
4.3.8 Aligning the door
For all appliances:*
WARNING
Risk of injury due to the door dropping out!
If the bearing parts are not screwed into place firmly enough,
the door may drop out. This may lead to severe injuries. What is
more, the door may not close and therefore the appliance may
fail to cool properly.
u
Screw the turn hinges firmly into place with 4 Nm.
u
Check all of the screws and retighten if necessary.
u
Align the doors flush with the appliance housing using the
two oblong holes in the lower bearing bracket if needed. To
do this undo the middle screw in the bottom bearing bracket
with the T25 tool supplied. Undo the remaining screws a
little with the T25 tool or with a T25 screwdriver and align
using the slotted holes.
u
Support the door: Take off the adjustable foot on the bearing
bracket using the open-ended wrench SW10 until it comes
into contact with the floor, then turn an additional 90°.
4.3.9 Fit the covers*
For appliances without a soft top mechanism:*
Fig. 22
The door is open 90°.
u
Position the bearing bracket and engage. If necessary push
apart carefully.
Fig. 22 (1)
u
Position the panel on the side and click into place.
Fig. 22 (2)
Fig. 23
u
Slide on the external cover.
Fig. 23 (1)
u
Close the upper door.
Fig. 23 (2)
4.3.10 Fit the soft stop mechanism*
For appliances with the soft stop mechanism:*
Putting into operation
12 * Depending on model and options
Loading ...
Loading ...
Loading ...