GSTD-Q User Manual

Loading ...

Fitting your Goldair Electric Blanket

FITTING YOUR GOLDAIR TIE DOWN ELECTRIC BLANKET

Place the Electric Blanket onto the mattress with the controller/s at the HEAD END.

Ensure the heating wires do not extend under pillows or hang over the sides.

The controller connection should be under the corner of the Electric Blanket at the

head end.

Ensure controller cable comes out from the blanket at a 45 degree angle towards the

head of the bed. The power cord must be positioned to prevent it being sat on or

rolled on when getting in or out of the bed. If the power controller cord is sat on or

trapped between the bed edge and the user on a regular basis it will be damaged over

time resulting in premature failure or fire.

1. Unroll the tie tapes and pass the tapes under the mattress as shown in the

diagram above.

2. Pass the middle tie cord under the mattress and through the middle loop on the

opposite side.

3. Pass bottom end of tie tape under the corresponding bottom corner of the

mattress then up through the centre loop of blanket and down under opposite

corner of mattress and then through side loop on opposite side of the blanket.

4. Repeat this process at the bed head end.

Loading ...

Goldair GSTD-Q Queen Tie-Down Electric Blanket