Loading ...
Loading ...
Loading ...
OVERLAY DOOR PANEL INSTALLATION - MP15C MODELS ONLY
Material Type #10 Wood Screw
Hardwood
¹
" (3.2 mm) Diameter Pilot Hole
Softwood
(2.8 mm) Diameter Pilot Hole
1
2"
screw
Step 4: Assemble the panel to the door
The preferred method of attaching the panel to the door
is to clamp the panel to the door so it cannot move while
drilling the screw pilot holes. Use bar clamps or "C" clamps
with pads on the clamping surfaces that will not mar the
panel or the door. The custom overlay panel should be
of the door. Drill holes through the gasket extrusion using
the 10 holes as pilot holes. Use the drill
abovethrough the front surface of
the panel. If the overlay panel is thinner than
5
8" (16 mm)
thick shorter screws will have to be obtained. Fasten the
panel to the door with the 10 screws provided in the
literature pack. Remove the clamps and replace the gasket
in the gasket extrusion
the gasket into the channels. Be
sure the gasket corners are seated properly.
Step 5: Install the door
Carefully open the top and bottom hinges on the door being
careful as there are many pinch points. Place the hinges
bottom and slide the door into position. Tighten the 4 hinge
screws with a phillips screwdriver. Place wire harness from
the grille and mount to the bottom of the door with the
screw and "P" clamp removed
Step 6: Secure the cabinet
3
4" black screws from the literature pack to
secure the counter top to the cabinet top through the holes
in the cabinet "Z" bracket.
Cabinet
"Z" bracket
3
4" black
screws
(3 places)
Loading ...
Loading ...
Loading ...