Loading ...
Loading ...
Loading ...
Inll II I .,,"l,,lll,',llllI I II I I _ I Ill I I I Ill lU II IlllIlll
SERVICE AND ADJUSTMENTS
J, i== = =,,,m,n i1 In = nil,
• Twist and push pulley into _-_rter housing.
Replace and tightenthe pulley screw.
III f I U Ill UlllUllll
Remove the roperetainer screw and removeany re-
maining rope.
Move away from thefuel tankand melt the end ofthe
rope tobe insta!led.Allow the meltedendtodroponce.
Then, while the rope is still hot, pullthe melted and
through a rag toobtaina smooth,pointedend.
• Feed ropethroughstarter rope hole instarterhousing.
• Guide the rope inside the pulley, then up through the
pulley hole. it may be necessary to push the rope
through with a small Phillips screwdriver inserted into
the small hole on the underside of the pulley.
• Wrap rope counterclockwisearound the pulleyratchet
and tuck loose end back under rope, leaving a 1" tail
between the retainer rib and screw post.
• Pull rope tightly as shown in the figurebelow.
• Install the roperetainer screwand tighten untilsnug.
Do not over-tighten.
° Rewindat!,_he rope ontothe pulley in a counterclock-
wise direction.
Starter :--:
Housing _.
Figure 56
o
Spring
Rope
Hole
"] Rope Retainer
Rib I 'PULLEY I Clockwise
Figure 57
Pulley o
Screw JJjjJJjJJj Pu,,ey
Figure 58
• Pullout 10" ofropeand catchrope intab in thepulley.
• Carefully turnthe pulleytwo completeturnsclockwise,
winding up the springby releasingropefrom the taD.
• While holdingthe pulley ratchet,pugthe excess rope
through thestarter ropehole, While .hpld!ngtension on
the rope, let ropeslowlYrewind intome housing.
p Spnng
,,.,,,,
11111
" _ Tension
Figure 59
Re nstai fan housingbyaligningthe fan housing tqthe
baffle plate and chassis. Then while ho cling the fan
housing against the chassis, pull the rope handle out
until you feelthe fan housing drop into placeagainstthe
chassis. Slowly,letthe rope rewind intostarter housing.
Reinstall the 4fan housing screws and tighten the 2 cyl-
inder cover screws. Fig. 54.
-24-
Loading ...
Loading ...
Loading ...