Loading ...
Loading ...
Loading ...
_,CAUTION: Before performing any
service and adjustments:
• Release control bar and stop engine.
• Make sure the blade and all moving
parts have completely stopped.
• Disconnect spark plug wire from spark
plug and place where it cannot come
in contact with plug.
LAWN MOWER
TO ADJUST CUTFING HEIGHT
See 'qO ADJUST CU]3-1NG HEIGHT" in the
Operation section of this manual.
REAR DEFLECTOR
The rear deflector, attached between the rear
wheels of your lawn mower, is provided to
minimize the possibilib/that objects will be
thrown out the rear of the lawn mower into the
operator's mowing position, Ifthe rear
deflector becomes damaged, it should be
replaced.
TO REMOVE/REPLACE DRIVE BELT
• Remove drive cover. Remove belt by
pushing down on gear case pulley and roll
bait oft.
• Turn lawn mower on its side with carbure-
tor and fuel cap up.
• Remove blade.
• Remove debris shiekt.
• Remove belt from engine pulley on
crankshaft.
• Install new belt by reversing above steps.
• Always use factory approved belt to assure
fit and long life.
o.vo_IHIk \
cover JI
Belt _ _/l_ N I
Pu h
down I
TO ADJUST HANDLE
The handle can be mounted in a high or
low position. The mounting holes in the
bottom of lower handle are off center for
raising or lowering the handle.
• Remove upper handle and all parts
attached to lower handle.
• Remove hairpin cotters from lower
handle bracket mounting pin.
• Squeeze lower handle in to remove it
from mounting pins.
• Turn lower handle over to raise or lower
handle.
• Squeeze lower handle in and position
holes onto mounting pins on handle
bracket.
• Reassemble upper handle and all parts
removed from lower handle.
Mowing ,_, Mowing _,
position F-_ position ,(-_
I i
Low position Highposition
4
handle
Rotat
14
Loading ...
Loading ...
Loading ...