Loading ...
Loading ...
Loading ...
General Care & Cleaning (cont'd)
Surface
Burner
Grate
To Clean the Recessed and Contoured Areas of the Cooktop =If a spill
occurs on or in the recessed or contoured areas, blot up spill with an absorbent
cloth. Rinse with a clean, damp cloth and wipe dry.
Burner
Cap
Surface
_/ (_rd_ Burner
/ _ Head
JOrifice
">7
To Remove and Replace the Surface Burner Caps and Surface Burner
Heads = Remove in the following order: (1st) surface burner grate, (2nd) surface
burner cap and (3rd) surface burner heads.
Reverse the procedure above to replace the surface burner cap and surface burner
heads, Do not remove any parts from the cooktop until they have
completely cooled and are safe to handle. Do not operate the surface
burners without the surface burner cap and surface burner head properly
in place.
To Clean the Surface Burner Caps andSurface Burner Heads =Use a soap-
filled scouring pad or a mild abrasive cleanser to clean the surface burner caps
and surface burner heads. The ports (or slots) around the burner head must be
routinely cleaned. If residue still remains in these ports, use a small-gauge wire or
needle to clean the slots or holes. For proper flow of gas and ignition of the
burner--DO NOTALLOW SPILLS, FOOD, CLEANING AGENTS ORANY
OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING.
ALWAYS keep the surface burner cap and surface burner head in place whenever
a surface burner is in use.
or
a Nail
Fig. 2
/
about 45
Oven Door
Hinge
Fig. 3
Removing & Replacing the Oven Door
The door is heavy. For safe, temporary storage, lay the door flat with
the inside of the door facing down.
To Remove Oven Door:
1. Open oven door completely (horizontal withfloor- See Fig. 1).
2. Remove 2 screws located on the inside ofthe oven door liner (See A Fig. 2)
3. Insert the 2 screws into the door hinge holes located onthe side ofthe hinge arm,
one into each hinge (See B Fig. 2).
4. Close oven door until the door stops, (Do not force the door to close any further).
The placement of these screws should keep door open in about a 45 degree
position.
5. Graspoven doorfirmlyon both sides and slidedoor up and offhinges atthe same
angle. (See Fig. 3)
6. To clean oven door, follow the instructions inthe General Care & Cleaning table.
To Replace Oven Door:
1. Be surethe hinge arms remain atthe45 degree angle position. Be surethe screws
are still locking the hinge arms from moving. If the screws fall out of the hinge
holes, the hinge(s) may snap back against the oven frame and could pinch fingers
or chip the porcelain finish on the oven front frame.
2. Hold door at the sides near the top while resting the lower front of door on your
knee. Insertthe door channels at the bottom of door over the door hinges, (See
Fig. 3).
3. Allow the door to slide down into the door hinges evenly at the same 45 degree
angle. The hinge arms should be inserted into the bottom corners as far as they
can go.
4. Open door completely (horizontal with floor) and remove both screws from holes
in door hinges.
5. Reinstall the 2 screws into the door liner (See C Fig. 2).
6. If the door is not in alignment with the oven frame, remove door and repeat the
above steps.
12
Loading ...